fdm-support
upgraded noctua fan and gantry printer says error heating up
gears ain't moving
Print quality issues
E3 pro 4.2.2 does homing and prime routine, then just stops right before its supposed to print
Printer suggestions
every print i make fails
Bed Offset Issue Ender 3 Pro
Best Hot end fan casings - Ender 3
Going Insane with printing issues
excessive filament extrusion while printer homes XYZ before print
Layer width inconsistency issues
Correct gcode for pause
HEATtOWER CURA total fail with Ender 3v2
Not printing
cannot get initial layer to stick - ender 3
budget 3D printer
Unreliable extrusion inspite of extensive maintenace
Color Bands
Waterproof petg
Ender 5 extruder not moving filament
Bedslinger Y-axis slipping
poor quality prints with stringing
possible wire burning?
Bumpy outer wall
v0.1 extution Problems
Mechanical Rubbing on Diagonal Traversal Ender-6
Sovol SV03 or Artillery Sidewinder X1, X2
Cura custom support body issue
Print Quality Issues
struggling to flash ender 3 pro firmware on my mks gen l v1.0 motherboard
FLSUN Super Racer - Bed adhesion issue + other issues
thing stuck on filament tube ender 3
Ender-3 s1 slight printing problems
voxlab problem
Heat block easily screws all the way to the heatsink
Chronic Clogging at Hotend
Ender 3 does not raise after finishing a layer
ender 3 mainboard not keeping wires in place
KP3S Z-wobble issues
Ender 5 extruder completely unresponsive
Weird bulge Ender 3
Printer is glitching
First layer issues with E3
Having a ton of issues with my ender 3 pro v2
cr10 smart firmware won’t work
Annoying slight overextruion on seams and in general
Z banding(?)
Under extrusion infill only
Ender 3 Pro Z Axis Binding
Trying to find a 3d printer (beginner)