it was running great yesterday idk whts the issue now ive tried varius sd cards and even usb yet no avail
i have a bltouch installed if thats important for yall to know
in the image the z stop is the unplugged one
#E3 pro 4.2.2 does homing and prime routine, then just stops right before its supposed to print
thorny meteor
tawdry oasis
it was running great yesterday idk whts the issue now ive tried varius sd cards ...
Did you try reslicing the file?
tawdry oasis
When you’re printing off sd card the printer won’t tell you if there are any gcode errors, it’ll just stop the print
So that’s likely what happened
Also if you have a bltouch then it might be that it probed that the bed was below the y minimum
Because the printer will give a gcode error if it tries to move outside it’s bounds
thorny meteor
Want me to send my start code ?
tawdry oasis
What I think is most likely happening (because that happened to me before) is that the probe measures that the bed is lets say -0.3 mm, so it’s below where the end stop is. Then if the nozzle tries to move there the printer will give an error since it’s below the minimum value
The solution is to basically just make the bed higher
tawdry oasis
If you want to be sure, connect your computer or something to the printer through usb and use pronterface to start the print
That way if there are any errors pronterface will show them
thorny meteor
What I think is most likely happening (because that happened to me before) is th...
Fixed
Thanks
Idk how to close these
tawdry oasis
Btw I wouldn’t recommend just using pronterface all the time for prints, since if your computer dies or sleeps mid print the print will fail, just use the sd card unless you’re debugging something