Printer is glitching

[inner seal]

So i don’t really know what’s happening and im panicking here. Pretty much all in the video

[copper sapphire]

You need to set up the limits of the printer properly, its trying to move outside of where it can go

the clicking and stuff is from the stepper motors skipping steps

on the first video the bowden tube is pulled really tight which means its going too far right, and on the second one its hitting the endstop which means its going too far left

in your slicer make sure the dimensions of the printer are set up right, it should be 235x235x250mm

[inner seal]

ive been using the pre set ender 3 settings for awhile, never really had this issue before with big prints till now

[copper sapphire]

what are the bounds in those preset settings?

[inner seal]

settings seem to be alright

[copper sapphire]

try reslicing the part

maybe the slicer just glitched

[inner seal]

i tried printing on an older file which worked fine when i did it before. same issue. but its worth a shot i guess

[copper sapphire]

also make sure the bowden tube isnt getting caught on anything

it seems pretty tight even for being out that far

[inner seal]

hmm it could be that