fix-my-print
T1 running fans at Overhang/Bridge speed when they should be at 0%
Other
Weird gaps in print walls
Extrusion
90 Degree corner issues
Errors
V-core 4.1 idex 500mm layer shift issue
Other
Irregular fine bumps on curved surfaces on a custom 600mm V-Core 4.1 IDEX
Other
Extrusion
Out of range
Errors
Benchy inside of Bug issue
Errors
Extrusion
Edge ripple
Errors
Calibrating for ABS and in general.
Other
Errors
Extrusion
weird flow calibration failures
Extrusion
VC3.1 0.6 nozzle
Other
Fuzzy skin artifacts
Errors
ribbed corners
Errors
Sinds the last update, I have serveral times a failout.
Errors
Generally crappy bridges…could any saint with decent bridging post their “standard” Orca settings?
Other
Under extrusion ONLY after long travel moves
Extrusion
PETG Cooling %
Other
Horrible quality on flat walls
Other
Bridging issue on inlet cone / bellmouth
Extrusion
Melted lines in my print
Extrusion
Question for the hive mind..What could be causing this?
Other
Extrusion
Print "Complete" before it's complete
Solved
Errors
inconsistent extrusion on top layers?
Extrusion
PETG Vcore 3.1
Extrusion
Multi material bed temperature issue
Other
Extrusion
Printing too high in rear of bed, and first layers have odd artifacts
Other
Speed w/ infill
Extrusion
Layer shift
Errors
Beacon First Layer Woes
Other
Unsteady extrusion at start of line
Extrusion
PA6-GF first prints look fuzzy
Extrusion
Vcore 4.1 idex print quality issues
Other
Small ripples are 90° corners
Extrusion
Vcore 3.1 - Bulging Corners
Errors
Extrusion
Ratrig Vcore 4.1 Hybrid tuning issue
Extrusion
Z banding?
Errors
Extrusion
Underextrusion at Start of the loop
Extrusion
. Is it possible to connect water flow sensor in ratos .
Other
Not smooth surface after upgrade to 4.1
Solved
Other
Is there an option to remove a failed part on you printer?
Other
Strange corner behavior
Extrusion
Retraction tuning - PETG
Other
Issues after vCore 3 2h migration
Extrusion
Problems with ace dragon volcano
Errors
Extrusion
Sparce infil not sticking..
Errors
Extrusion
Reenable wipe on filement runout with RatOS 2.1 RC4?
Other
Extrusion
Heater don’t shut off while heatsoaking
Errors
Odd band on bottom of walls near support.
Other
Extrusion
Z Height Dimension Issue
Other
Nozzle Digs Bed at Start of print
Errors
Extrusion