fix-my-print
Z banding
Extrusion
Print issue
Solved
Extrusion
Ridiculously low flow ratio
Extrusion
At the end of my first tool change it tries to move to -60
Solved
Errors
Under extrusion after first layer
Solved
Extrusion
Weird print defect
Solved
Extrusion
Weird artefacts on outer walls
Errors
unsatisfied with my V-Minion print quality (VFA, ringing, z inconsitencies)
Other
Extrusion
Calib Cube Sanity Checks
Extrusion
Ghost/wave effect
Errors
Extrusion
Melted bottom layers
Other
Extrusion
A artifact on tall prints v core 4 hybrid 500
Errors
Prints Warping Off the Bed
Solved
Other
PETG defect on same place of print
Extrusion
V-core 3.1 loosing my mind
Extrusion
VC 4 500 - flush T0 after each change? (VarioShore + Suport Problem due to long parking)
Other
Extrusion
Why this happens?
Other
Artifacts and bad overall quality for first ABS print.
Extrusion
Rough ABS top layer
Extrusion
Ratrig calibration cube results
Errors
Almost gaps in print
Other
Layer shift multicolor idex
Other
Massive random later shift after first layer
Other
Bad z-seam
Extrusion
Calibration cube tuning
Errors
Extrusion
Bad outer Surface quality with voids
Extrusion
inconsistent first layer
Errors
Extrusion
Can some explain to me like I'm 5 years old why my z-offset / first layer is different every time?
Solved
Other
Adhesion issue
Other
Infill is not supporting the print
Other
Weird little extra bits on my wall.
Other
Extrusion
beacon calibration
Solved
Artifacts? Too much jerk?
Solved
Other
Poor Top Layer
Errors
IDEX retraction and flowrate?
Extrusion
First Layer progessively gets too close VC4 500
Other
Extrusion
Nozzle lifting itself while printing first layer
Other
Extrusion
IDEX blobs
Solved
Other
Extrusion
Pessure Advance
Extrusion
Troubles with first print
Other
Extrusion
Corner Pattern with 0.8mm nozzle
Extrusion
Rough top layer
Other
SO MUCH GHOSTING
Other
Extrusion
First layer squish increasing with time VC4 500
Other
Extrusion
First layer issues Looks to close and to far away at the same time.
Other
Fuzzy lines / underextrusion?
Other
Extrusion
Tons of woodgrain, how can this be fixed?
Extrusion
Front right corners lift
Other
Strange artefacts on VFA tower
Other
Temps T0 and T1 not right during IDEX print
Other