fix-my-print
Weird little extra bits on my wall.
Other
Extrusion
beacon calibration
Solved
Artifacts? Too much jerk?
Solved
Other
Poor Top Layer
Errors
IDEX retraction and flowrate?
Extrusion
First Layer progessively gets too close VC4 500
Other
Extrusion
Nozzle lifting itself while printing first layer
Other
Extrusion
IDEX blobs
Solved
Other
Extrusion
Pessure Advance
Extrusion
Troubles with first print
Other
Extrusion
Corner Pattern with 0.8mm nozzle
Extrusion
Rough top layer
Other
SO MUCH GHOSTING
Other
Extrusion
First layer squish increasing with time VC4 500
Other
Extrusion
First layer issues Looks to close and to far away at the same time.
Other
Fuzzy lines / underextrusion?
Other
Extrusion
Tons of woodgrain, how can this be fixed?
Extrusion
Front right corners lift
Other
Strange artefacts on VFA tower
Other
Temps T0 and T1 not right during IDEX print
Other
IDEX Boogers
Extrusion
Zig zag
Other
Unclean extusion in inner wall/internal solid infill
Extrusion
Inconsistent walls Vcore 4 500
Errors
First layer was good and the second layer is crashing into the first layer
Other
Errors
Extrusion
Rotating parts and hings stick and not turn.
Errors
Wavey first layer and wierd layer artifacts
Other
Larger layer time causes visible line on external perimeter
Extrusion
First Layer solid infill starts faulty...
Extrusion
Is this extreme resonance?
Other
Extrusion
Funky extrusion
Extrusion
Infill intersections not connecting
Extrusion
Weird artifacts at corner
Solved
Other
Lines Not straight
Other
Lots of VFAs and layer shifts
Other
Tons of stringing out of nowhere
Extrusion
What settings to start with for tuning?
Other
Some rare stripes.Are these filament impurities or other causes?
Errors
Under extrusion?
Extrusion
Vaoc off by ~100 mm
Solved
Other
Errors
Under extrusion with default settings
Extrusion
First Layer Issues
Other
Terrible 1st layer - bad mesh, tape or twisted frame? Vcore 3.1 300
Other
1st Layer - Filament-flow
Extrusion
Anyone experience this?
Extrusion
Rough Top Layers
Extrusion
Replaced my hotend, now I can't get a good first layer
Errors
VC4 LDO Orbiter 2 Funky Extruder
Extrusion
Toolhead Vibrating While Idle – Humming Noise
Other
Nozzle wipe
Other