voron_2_help_forum_public
sensorless homing and bed mesh issues
Bed mesh issue
Initial setup
CB1 Wont Flash
Initial setup
used ldo voron 2.4 or new "lower quality" voron kit?
Kits/parts advice
Hello,
Initial setup
Vendor Suggestions
Kits/parts advice
Where to start with Voron Build [Noob]
Kits/parts advice
Mechanical
Initial setup
Trouble with actuating the extruder motor during prints
Electronics & wiring
Error on inserting Skew correction commands in console
Configuration
Resonance Problems
Tuning
Tap
Mechanical
Homing all Y doens't home properly (virtual_endstop)
Tuning
First print
Configuration
Voron 2.4 48v for a/b motors
Electronics & wiring
Linear Rail Alignment Tool
Kits/parts advice
Mechanical
Stuck on Initializing
Solved
Electronics & wiring
BTT HDMI5 causing network issues
Electronics & wiring
Configuration
Issue squaring the gantry
Kits/parts advice
Mechanical
neopixel wont turn on and klicky pcb is lighting up but won't change state when pressed.
Solved
Electronics & wiring
Configuration
Print doesn't connect on first layer in certain places?
Mechanical
First layer
tap tolerence
Mechanical
Prints angled towards back of printer.
Mechanical
ABS fumes vs Exhaust filter
Tuning
Klicky crash after z offset adjustment
QGL
Recovering from burning out Octopus Pro board
Electronics & wiring
to many retraction during prints
Tuning
Wired Heater Cartridge Error
First print
Unable to Quad Gantry Level
Mechanical
QGL
LEDs not behaving
Solved
Electronics & wiring
Configuration
[Solved] No trigger on x after full movement, with mellow tmc 5160 pro on SPI with Octopus
Initial setup
Electronics & wiring
Configuration
Nonfunctional parts
Kits/parts advice
gantry print issue
Kits/parts advice
Initial setup
Bad quality backside of print
First print
Solved
Voron 2.4 Bed Adhesion Issues
Tuning
First layer
clockwork 2. extruder stopped pushing filament
Kits/parts advice
Mechanical
Octopus Pro stepper communication issue [solved]
Printer shutdown
Electronics & wiring
XY endstop location withCanbus
Mechanical
Kits/parts advice
I am not able to do my qgl. Probe points are increasing.
Z Offset
Electronics & wiring
QGL
2.4r2 pin mod on XY joint - replace idler with sandwiched bearings?
Mechanical
Solved
Extrusion Issues
Mechanical
Faster quad gantry leveling with beacon?
QGL
Z2 stepper moving faster than the other 3 steppers?
Tuning
Mechanical
Configuration
moved printer to final resting place and got error Unable to read tmc uart 'stepper_x' register IFCN
Mechanical
Initial setup
Solved
Electronics & wiring
Rapido v2 hf keeps clogging for some reason
Mechanical
Solved
Silicone heater pad glue - RTV and alternatives
Kits/parts advice
Solved
Park printhead in front insted of back after print.
Configuration
Input shaper
Tuning
Solved
Post Print issue, toolhead losing either position or steps or current?
Solved
Installing Mailsail
Initial setup
Configuration
Voron door hinges for 6mm thick panels
Mechanical
Self-source or Kit?
Initial setup
Solved
Flashing EBB SB 2209 and Initial Config... Which First?
Initial setup
Configuration
So many Toolhead combinations and choices..
Kits/parts advice