Wired Heater Cartridge Error | VORONDesign | Page 1

molten ruin May 15, 2024, 7:03 AM

#

Hello Everyone,
So, every time I start a print and everything is going fine lays the first layer, and once it lays the second one I get an error about my heater not heating as expected. It goes into complete shutdown, now from what I read online apparently the PSU is the issue so I bought a 350W PSU and installed it and the same error came up. IDK what the heck is going on FYI I changed the PSU, Thermistor for the hot end and the heater cartridge any help or guidance would be greatly appreciated

#

📎 klippy_9.log

timid wing May 15, 2024, 3:27 PM

#

Have you done a PID autotune of you're heater yet? What heating element/hotend are you using?

alpine topaz May 15, 2024, 3:32 PM

#

molten ruin Hello Everyone, So, every time I start a print and everything is going fine lays...

It looks like you're just outrunning your hotend to me. What hotend & heater?

molten ruin May 15, 2024, 9:36 PM

#

https://www.amazon.com/gp/product/B0B4CC1BFW/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1

2-Pack Upgrade 6x15MM 24V 65W V6 Hotend High Temperature Heater Car...

This heater has high quality, and uses closed stainless steel sleeve, much higher quality than the common heating tube on the market.

#

heater cartridge

#

and a dragon hot end

#

and yes i did pid tuning

#

also one thing i thing its the ldo nighthawk issue tbh cuz once i disconnect the part cooling fan and run it, it works with out a problem

alpine topaz May 15, 2024, 9:51 PM

#

Just dragon? Aka, not HF or anything? Ya...you're just printing too fast, and outrunning it

#

Do you have the sock installed?

molten ruin May 15, 2024, 10:04 PM

#

yup

#

any recommendations

#

do u think i should just plug the heater to the control board instead of the tool head board (night hawk ) ]

#Wired Heater Cartridge Error