Kav displays

[crude valley]

Hi has anyone had any success with the Kav displays and Prosim A320 ? For example I have the correct displays showing in the EFIS, like pull Goes to STD on display, push will show HPA and QNH label. I have also assigned the INCH to an output but when it’s pushed it will show the HPA bit when I try to change it with the encoder it flickers and tries to show both HPA and INCH at the same time, even though it’s in HPA mode (confirmed in Prosim) i assume there must be a formula or something for this, any ideas ? Thanks

[ancient wigeon]

hi Jammur, hpa and inch will still have values even when just populating one on the screen. There are a couple of ways of doing this. May I ask, are you using one output event for HPA and one output event for Inch (in which case a simple pre-condition would work to inly activate one at a time) or are you using a single output event?

[crude valley]

Hi MM I have tried using both a single and 2 outputs it just does the same thing, im unfamiliar with pre conditions. Any help would be apprciated or even if yiu could screenshot the settings i can have a look at it ?

[ancient wigeon]

so while I have a kav display I’ve not used it for years in my setup since the cheaper commercial fcu’s came out. I can screenshot which events I use and any preconditions though

[crude valley]

That would be fantastic thank you !

[ancient wigeon]

if I don’t get chance by Friday please do give me a nudge

[crude valley]

nudge

[ancient wigeon]

sorry for delay (dm sent) I’m away this weekend but have found an upload of my whole config here: #1421515777013579948 message

[crude valley]

No problem thanks a lot I’ll take a look at it 🙏🏻