fix-my-printer
Need probably basic Linux help with numpy package and my path
other
setup
First Layer problem. Z-shift
motion
Bearing getting unseated on hybrid motor
motion
Virtual Endstop -> Beacon
setup
Gantry twist wierd
motion
Solved
Belt grinding + toolhead jumping Vcore4 500
motion
Raspberry Pi connection Problems
setup
Crushed beacon
other
MCU lost Connection on toolhead_t0 but Klipper still have input hardware
other
camera
Solved
setup
Steppers skip when toolhead tries to move to primeblob location
motion
other
Solved
Must home axis first: 0.000 0.000 15.000 [0.000]
setup
vc4_led_holder_frame not in printed parts bundle?
other
Flashing octopus
setup
Layer Shifts when Printing (VCore 4 - IDEX 400 - Single tool mode)
motion
Solved
setup
Error after Z-Tilt Calibration When Printing: No trigger on probe after full movement
motion
other
MCU not connecting
other
setup
Abnormal probe offset detected
Solved
other
Printer constantly pauses with no obvious reason
motion
Bed Heater Intermittent Heating (V-Core 4 500mm)
other
bad vertical finish
motion
VC4 IDEX copy mode
Solved
motion
VAOC Calibration Issue
other
BOTH Part Cooling Fans don't work (IDEX)
motion
other
setup
ADC Out Of Range - Strange Issue
other
setup
Printer needs config updates after turning it back on.
setup
voron 2.4
Solved
setup
Need help with my Orbiter Runout Sensor
setup
Just finished up my printer and this is the first thing i got.....
Solved
setup
Suddenly toolboard_t0 ADC out of range
other
Help with VCore 4 Champer lights
Solved
setup
Heated bed not heating
Solved
other
heater_bed not heating at expected rate
setup
Using Part Cooling Fan turns Controller Fans off
other
Beacon_Initial_Calibration failing on new build
setup
Bed adjustment Vcore 4 500
motion
V-Core4 - Error when trying to print
setup
Input Shaper and Belt Tension Results VC4 400mm.
motion
z tilt
motion
VCore 3.1 - Heater extruder not heating at expected rate
Solved
setup
Pi undervolted?
other
setup
Lost Communication with MCU 'toolboard_t0'
other
Trouble installing RatOS, configured Octopus v1.1 board but consistent error message
Solved
setup
Fresh install of ratos. My manta m8p 1.1 and cb1 is struggling.
other
setup
Uneven first layer issue, some areas high, some low.
other
Lost Communication with MCU
other
Reinstalled RatOS. Extruder now says it's 193c when it's cold. I forgot how to fix this issue.
Solved
other
I've had to replace my sd card in my manta m8p v1 cb1 board. Struggling to flash.
Solved
setup
New build no hotspot
setup
bed temp not being recognized after reflashing rat os.
setup