fix-my-printer
Vcore 4 idex 500 Bad printout
setup
Bed Adhesion
setup
New heat block reading wrong vcore3
Solved
other
setup
Beacon always triggered and Fan 7 not working even with power applied
setup
Desperate plea for help
setup
VAOC Camera Issue
other
The first several layers (5-8mm) of all prints lean forward about .3mm
motion
Bed Assembly step 4
Solved
setup
VC3 unable to read driver UART
motion
Solved
The fans and heaters turn off automatically mid print
Solved
Accelerometer Help !! Invalid adxl345 id (got ff vs e5)
setup
Need probably basic Linux help with numpy package and my path
other
setup
First Layer problem. Z-shift
motion
Bearing getting unseated on hybrid motor
motion
Virtual Endstop -> Beacon
setup
Gantry twist wierd
motion
Solved
Belt grinding + toolhead jumping Vcore4 500
motion
Raspberry Pi connection Problems
setup
Crushed beacon
other
MCU lost Connection on toolhead_t0 but Klipper still have input hardware
other
camera
Solved
setup
Steppers skip when toolhead tries to move to primeblob location
motion
other
Solved
Must home axis first: 0.000 0.000 15.000 [0.000]
setup
vc4_led_holder_frame not in printed parts bundle?
other
Flashing octopus
setup
Layer Shifts when Printing (VCore 4 - IDEX 400 - Single tool mode)
motion
Solved
setup
Error after Z-Tilt Calibration When Printing: No trigger on probe after full movement
motion
other
MCU not connecting
other
setup
Abnormal probe offset detected
Solved
other
Printer constantly pauses with no obvious reason
motion
Bed Heater Intermittent Heating (V-Core 4 500mm)
other
bad vertical finish
motion
VC4 IDEX copy mode
Solved
motion
VAOC Calibration Issue
other
BOTH Part Cooling Fans don't work (IDEX)
motion
other
setup
ADC Out Of Range - Strange Issue
other
setup
Printer needs config updates after turning it back on.
setup
voron 2.4
Solved
setup
Need help with my Orbiter Runout Sensor
setup
Just finished up my printer and this is the first thing i got.....
Solved
setup
Suddenly toolboard_t0 ADC out of range
other
Help with VCore 4 Champer lights
Solved
setup
Heated bed not heating
Solved
other
heater_bed not heating at expected rate
setup
Using Part Cooling Fan turns Controller Fans off
other
Beacon_Initial_Calibration failing on new build
setup
Bed adjustment Vcore 4 500
motion
V-Core4 - Error when trying to print
setup
Input Shaper and Belt Tension Results VC4 400mm.
motion
z tilt
motion