fix-my-printer
I just tightened my belts? just a question.
motion
The best way to restore RatOS
setup
failed to init Unable to read tmc uart
setup
Skew Correction?
other
setup
Printer wont connect to klipper
other
Initial Homing
motion
setup
Home z not probing center of bed
motion
Bed not heating
setup
ADXL connection to RPi
setup
[Solved] All PT1000 sensors showing 13 degrees higher
other
setup
bad marshal data
setup
Probing/Bed Mesh again after priming nozzle
other
Bed Not Heating
setup
hdmi 5" wrong resolution (MANTA M8P + CB1)
setup
ratrig wiring guide and pinout from google are different. which order do my steppers motor wires go?
setup
mcu unable to connect
setup
Printer won't boot properly after Christmas
setup
z probe issues
other
SolvedPrinting orientation
other
Z-probe status is always triggered
setup
v-minion motors sound
motion
inaccurate Y axis
motion
setup
No trigger on x after full movement ?
setup
nozzle suddenly destroying sheet
motion
Toolhead clicking sound
other
Changing hottend cfg help
setup
Assembly issues with pulley - belt position.
motion
Heating or fan issue?
other
ADXL sensor
other
Motors have high pitch sound when enabled
motion
Issue with bed leveling
other
setup
Config Question
setup
Klipper reports SHUTDOWN
setup
BL Touch calibration, help.
setup
Adxl345 invalid id got 1c vs e5
motion
setup
I think I just opened Pandoras Box, TRIED TO UPDATE
setup
LDO Input Shaper Toolkit Reports Invalid adxl345 id (got ff vs e5)
setup
One Z Stepper changed direction
motion
(SOLVED) V-Minion error “Print exceeds max extrusion”
other
setup
EBB42 ADXL not working
setup
Best way to route filament with Enclosure 2.0?
setup
V-core3 overheats after homing in 2 minutes and shuts down
other
4028 Fan
setup
Minimum Temp
setup
what is going wrong here?
other
Cold printer rams bed into nozzle due to leftover ooze
setup
(SOLVED) SKR 2 Fan2 incorrect socket?
setup
Bed not heating
setup
Pinda Probe
setup
Help - Stepper Issues
motion