fix-my-printer
Z offset does not work consistently..
setup
Klipper is not running (Yesterday it was)
other
cable and motor buzz from 80-120mms
motion
other
setup
FFSAKE I put so much effort into my belt alignment and now this
motion
Dam it looks like I had a false run out detection with my Orbitor sensor. Anyone else experienced
other
shutdown and x motor problems. x motor
motion
setup
I know its look cool but.
other
Not able to connect to VCore3.1
other
setup
z probe not working
motion
X motion jerking in Y direction, losing center.
motion
Selecting Load Filament Unloads (LGX Lite)
setup
Bed heater
other
[Errno 16] Device or resource busy 'devbtt-octopus-11'
other
How do you do the X axis mod. Specifically how the the 3d printed parts attach to the ends.
motion
setup
stepper buzz
motion
Thermal Runaway
other
Phaetus rapido sudden temp plunge
other
MCU shutdown when homing (BTT octopus F446)
other
Bed heater
other
Has anyone ever wired one of these into the Ocopus
other
Mesh Generation - No trigger on probe after full movement
setup
I have wired up my 4028 Sanyo as per this guide and made alterations in printer.cfg how do I test?
setup
Flow issues
other
The build from Hell continues
setup
Left Stepper Not Working
setup
I need to reverse the direction of the extruder motor. Can I do this in config rather than risk dam
setup
SKR 2 will not flash firmware
setup
Waves on printed parts
motion
other
setup
Phaetus rapido heatbreak clogging
other
vc3 rapido uhf issue
setup
Ruby nozzle issues
other
Misalignment in the pulleys
motion
new x endstop always triggered
motion
setup
TMC 'extruder' reports GSTAT 00000001 reset=1(Reset) after 20 hours of print (again)
motion
setup
motor failing when using true bed leveling
other
setup
X axis wobble along Y during X motion (and vice versa)
motion
Third Part Cooing Fan
setup
FAQ
FAQ
info