fix-my-printer
Homing problem with "ratOS_homing" not valid section
motion
other
SD card seems to be full
other
Y axis Bearing vibration
motion
Z Step
motion
Correcting Skew
motion
setup
AWD Stepper Motor problem
motion
Cannot connect anymore to Moonraker server through another pc
setup
Option 'serial' in section 'mcu' must be specified
other
Sensor less Homing not properly working
motion
can't get 4028 part cooling fan to work.
other
Upgrading from lgx to orbiter and doing the toolhead upgrade I have underextrusion
motion
setup
Hotend seems to be running hotter than reported
other
[solved] Move out of range at start of print
motion
other
Setup Skrat No Power light
other
setup
Minion down
other
vminion x axis homing/ loud stepper
motion
VC3.1 500 bed not heating
other
Rapido UHF Hot-ends... Junk???
other
Hotend heats up at power on
setup
Move out of range: 20.000 -7.000 2.000 [0.000]
motion
setup
Bowden tube friction
other
Problems with an new Build
setup
Klipper errors after 2nd M600
motion
[solved] Extremely long wait after prime blob
other
the gates belt sliding down
other
A power surge when I turn off my printer.
other
Nasty hot end collision and now I'm getting this on my bed meshes.
motion
Can't set Z offset
other
setup
Eva3 + beacon problem
setup
BTT Smart Sensor Pauses after Prime Blob, Doesn't detect during print.
other
setup
Aggressive Vibration on second hand v core 3.1
motion
setup
Commissioning: can't do PID, no voltage to SSR/hotend heater. Octopus/Rapido HF/stock bed.
other
setup
Stepper Motor Direction?
motion
V-Minion Y-axis slipping
motion
My printer thinks it's rotated 90degrees
motion
setup
Nozzle is hitting the layers (infill) at full speed. (V-Minion)
motion
setup
Ratteling Noise on diagonal moves (V-Core 3.1)
motion
Big Layer Shifts
motion
Belts moving vertically + visible damage on belt after 1 day of prinitng.
motion
issue: hotend pid tune with fan
setup
Tightening xy joiners makes rails not smooth
motion
🤦♂ Resolved: X and Y swapped movement
motion
Z Movement Clicking? Bad noise
motion
remove magnetic adhesive sheet.
other
y axis skipping at accel > 5k (V-core 3.1 500)
motion
Bed Not Heating
other
[Solved] New 500 build. immediately clogs
setup
SOLVED: BAD BAD BAD noise when moving head quickly
motion
setup
Every now and then Stepper_z1 doesn't enable properly.
motion
Slow down Z axis only while "meshing"?
setup