fix-my-printer
Z-Tilt Issue
setup
Rear of print bed always lower than front
setup
Z-Tilt is only adjusting one Axis.
motion
setup
Update crash
motion
other
setup
When homing z the probe doesnt trigger and rams the hotend in the bed
motion
other
Solved
Upgraded my toolhead on RR3.1 and the printer has gone full stupid.
motion
Solved
metal "klunking" noise and seemingly loosing steps
other
skipping A and B's
motion
setup
Bed level issue - wave in my bed mesh and copy / mirror prints on T1 result in waaaaaay to low z
other
Random "Error during homing (....): Communication timeout during homing" at start of prints and VAOC
motion
Solved
Trouble understanding head selection and temp settings in Mainsail using Orcaslicer
motion
setup
Turn off part cooling fans when klipper is booting / offline
Solved
setup
VAOC not working
setup
Zero Division Error
setup
! Hotend fan on when should be off !
Solved
setup
X cariage moves slightly along the Y axis while homing X axis
motion
bed won’t heat
other
vcore4 hybrid flashing issue
setup
Weird sound from belts.. can’t find the cause
motion
Hotend moving back and forth.
motion
New Hotend for v-minion v1.0 and eva 2.4.2
other
lost communnication with MCU 'toolboard_t0'
other
Error evaluating 'gcode_macro _START_VAOC:gcode
Solved
other
Frequent Issue - MCU 'mcu' shutdown: Timer too close
other
MCU Shutdown (only on idle) VC4
other
Abysmal Flow
Solved
other
Z-Offset is not saved VC4 - firstlayer
motion
other
setup
Solved
First layer extruder temp error
Solved
other
setup
Keenovo Heater pad not heating
Solved
other
Heater extruder not heating at expected rate
Solved
other
Installing KlipperScreen
other
RatOS Configuration repository v2.1.x: v2.1.0-RC3-75 > v2.1.0-RC3-82 Invalid
Solved
setup
very odd temp graph
other
Failed homing of tool heads on V-Core 4 IDEX 500
motion
Solved
setup
weird camera and mainsail behavior
other
Fan runs at 100% no matter what
Solved
setup
Firmware SHUTDOWN: MCU fried?
Solved
other
IDEX Problem 2nd Layer move
Solved
setup
Option 'allow_unknown_gcode_generator' is not valid in section 'ratos'
setup
v-core 4 idex
Solved
other
setup
mcu 'mcu': Unable to connect
Solved
setup
Internal error during connect: module 'extras.resonance_tester' has no attribute 'SweepingVibrations
other
lost of conenction with mcu?
other
Idex upgrade, "ADC out of range" - is there something wrong with my Rapido?
Solved
setup
new ratos update, now cannot print
other
VCore 4 500 IDEX Homing shakes the printer violently
motion
Solved
VCore 4 500 IDEX Toolheads move when moving gantry in Y
motion
Solved
V4 idex z offset issue
setup
V-Core 3.1 PT1000 ADC out of range (toolboard fault, unknown cause)
Solved
other
setup
First layer prints fine then Extruder stops working
setup