fix-my-print
Cracks/under extrusion in layers
Extrusion
Horizontal Artifacts?
Extrusion
Intermittent extrusion
Extrusion
Heater extruder not heating as expected rate
Errors
Brown ABS turning paler in corners and edges of holes
Other
How to address pillowing?
Extrusion
weird extrusion artefacts.
Extrusion
Getting FDC to work cant install scipy
Other
Errors
Possible under-extrusion on infill
Other
Extrusion
MH Build Series PLA Has Horrible Stringing
Other
Extrusion
weird rough surface
Other
Help tuning print settings.
Extrusion
wobble in walls and sinking top surface
Other
Extrusion
Troubleshooting benchy (heat issues)
Other
2Prints dont Fit together
Errors
gap in Z seam
Extrusion
The ripples! Wavy/rippled surface.
Extrusion
underextrusion or other issue
Extrusion
Heavy underextrusion on any line break
Extrusion
failed prints only on one side
Other
Extrusion
Asking for PrusaSlicer Premade Config
Other
Extrusion
is this the extruder doing?
Other
Extrusion
weird artefacts everywhere+uneven layer stacking/uneven extrusion
Other
Errors
Extrusion
perfect first layer but bad subsequent layers
Extrusion
First layer calibration not working properly?
Other
small blobs everywhere
Other
belt ripples artifact
Other
Errors
Strange oozing
Extrusion
Dramatic later shift every layer
Errors
Poor Bed adhesion
Other
printing round tubes
Extrusion
Cannot finish print
Other
petg issues
Other
Extrusion
Linear movement analysis, vertical pattern
Other
what is this?
Errors
Extrusion
Uneven extrusion on thin wall
Other
Extrusion
Physical waves on print surface
Other
Extrusion
Underextrusion New Printer
Extrusion
I don't even know where to start. insanely bad quality.
Extrusion
Box lid doesn't fit
Other
Can't figure out what's wrong. Very poor print quality.
Extrusion
calibration cube weird defects
Other
Errors
Trying to print 85A tpu
Extrusion
Random clogging?
Extrusion
not adhering to lower layers
Other
Bridging over infill destroying prints
Errors
Extrusion
PA is changing it self
Other
Bad Infill
Extrusion
RatRig/3DO ASA Green - printing problems on the Bambu Lab X1C
Extrusion
[Solved] Gaps in between perimeter sharp turns
Other
Extrusion