fix-my-print
over extrusion and under extrusion on the same print
Errors
Extrusion
Inconsistent First Layers vcore 3.1 w .6mm nozzle
Errors
Extrusion
Second Hand 3.1 with 0.8mm Nozzle not printing
Extrusion
holes in print
Other
Extrusion
Gear like pattern on some round shapes
Other
PLA overhangs are utter mess
Extrusion
Print got messed up midway
Other
Errors
Gaps at end of perimeter
Errors
Extrusion
layer cracking
Other
Errors
Nylon cf-15
Other
Endless Layer Shifts
Other
Extrusion
1st layer issues
Extrusion
Inconsistent Extrusion after travel
Extrusion
Very strange corners
Other
What is causing my print to loosen from buildplate? z_offset?
Other
circle not round
Other
Extrusion
Cant print a first layer correctly
Errors
Gradual overextrusion
Other
Extrusion
Surface gaps on Radii
Other
Surface Artifacts
Other
PETG problem around seam
Extrusion
Extrusion issues after retraction
Extrusion
"Ripple" on bottom and top layers
Other
Extrusion
Problems printing PETG
Other
Uneven first layer
Other
Please, I need help. Some bits of the first layer always get scraped up by the nozzle.
Errors
Any advice? First layer came out fine. (3D Benchy, PLA, V-Minion, 15mm layer, 1.75mm filament)
Other
First Layer has Lots of Gaps?
Other
Z-Banding V Minion
Errors
Issues with “long blobs”
Other
Extrusion
V-minion z-wobble or banding
Other
Errors
Getting some ringing effect..HELP!
Other
Errors
Extrusion
ASA overhang problems
Other
Printed parts not aligning properly
Other
Errors
Lots of vibrations in the print even after IS
Errors
Consistent 2mm Z banding. 3.1
Other
ripping/tearing of first few layers in one local spot on large print.
Other
Errors
Extrusion
Issue with overhang first layer and support bridging
Other
Overextrusion after internal top layers
Extrusion
Stringy prints
Other
1st print great, 2nd print cracking/seperation
Other
Strange Artifacts on First layer
Errors
PCTG curved surface
Other
Poor bridging on first solid top layer
Extrusion
fuzzy skin
Extrusion
Gaps at the end of perimeters
Errors
PETG, what to adjust?
Extrusion
Bad Print Settings? - Nope......Nozzle
Extrusion
weird layers
Extrusion
subtle wavyiness surface finish
Other
Errors