ratos-support
Stop services automatically
Other
Unable to update RatOs repo after branch change
Errors
ratos vanished
Solved
Configuration
Boards
Possible to Not Home between prints (multicolor)?
Configuration
Customization
Board detected but unresponsive
Errors
Boards
ratos + octoprint
Configuration
Other
Part cooling fan help needed
Configuration
Boards
prusaslicer gcode freezes printer
Other
Adaptive Mesh: Did I find an error?
Configuration
latest ratos update (5-31-23) throws error
Macros
Errors
Extruder Rotation Distance
Configuration
invert endstop pin?
Configuration
Job queue & mainsail config
Configuration
Getting "Timer too close" errors 95% of all prints.
Solved
Errors
Cant tell what happend mid print it stopped
Errors
How should do to adjust the firmware.config to enable CONFIG_INITIAL_PINS="xx_xx" permanently.
Configuration
Customization
Boards
Unable to read tmc uart 'extruder' register IFCNT
Solved
Errors
Configuration
Motion
RatOS unstable since Crowsnest update
Errors
No trigger on z after full movement
Solved
Errors
Motion
Adaptive Mesh and Orca Slicer
Customization
Orbiter Filament Sensor 2.2 not working properly
Solved
Errors
Configuration
Klipper reports: ERROR Duplicate Chip name 'probe'
Solved
Configuration
TMC 5160 pro for stepper X and Y Problems
Solved
Errors
Configuration
Motion
Making max_accel_to_decel proportional ?
Configuration
ResHelper on RatOs?
Macros
Customization
Webcam not found after Update to Crowsnest v4
Solved
Configuration
Adaptive mesh
Macros
Configuration
RatOS giving errors communicating with LDO Input Shaper kit
Solved
Errors
Boards
Install RatOS on a fresh Armbian install
Solved
Configuration
Info
Other
Customization
reverse y axis
Solved
Motion
Timelapse failing
Other
RatOS Adaptive Mesh requires manually editing bed_mesh horizontal_move_z
Macros
Motion
Webcam is broken after Crowsnest update
Solved
Configuration
Webcams freezing up.
Other
[Help] After updating, the print quality turned to 💩.
Solved
Configuration
Prime location
Solved
Configuration
Customization
Two controller fans with PWM
Configuration
Customization
moonraker warnings
Solved
Errors
Upgrade while keeping history link?
Solved
Configuration
v0.11.0-201-g37315bf3 prints prime blob off plate
Other
Default printer.cfg ADXL default.
Configuration
Save config error when setting position endstop offset
Errors
Configuration
Lost Extruder Temperature Control after latest RATOS update during PrimeBlob
Errors
Bed Heating Problem when starting print
Errors
Rpi touchscreen blank with backlight on after bootup
Errors
ratos adaptive bed mesh not working with cura
Configuration
errors since using ratos adaptive mesh
Configuration
Klipper install dirty after update of ratos and klipper
Solved
Other
Octopus not recognised
Solved
Configuration
Native RatOS Adaptive Bed Mesh hits the bed in prime location
Macros
Motion