klipper_kalico_help
menuconfig not showing options for STM32
Flashing
z_tilt z_positions needs exactly 4 items for bed slinging hybrid_corexz
Meshing & probing
WS2812B Neopixel fail to control full chain
Macros
Config
Moonraker failing to connect to Klipper.
Connectivity
Error after updating klipper and after trying to update mcus nothing helps
Installation
Solved
Clicked update bttn
Flashing
Home All sends motors in different direction than Home X and Y independently.
Installation
[solved] attempting to flash voron display, but limited config options shown
Flashing
BedFans.cfg from Ellis breaking my Additional Heater
Macros
Klipperscreen splash screen not working
Klipperscreen
RBP&BTT Pico
Installation
Connectivity
Flashing
Basic question regarding QGL
Meshing & probing
Formbot Voron 2.4r2 Config (M8P V1.1, CB1, EBB RP2040 & TAP)
Error messages
Config
Error Z offset : SAVE_CONFIG section 'stepper_z' option 'position_endstop' conflicts with included v
Error messages
Config
IFCNT Error
Connectivity
mks robin nano v1.2 unable to connect to mcu
Flashing
crowsnest - C920 - Autofocus setting crashes the camera
Camera
!! Lost communication with MCU 'EBB'
Connectivity
klipper screen help
Connectivity
Klipperscreen
Extrude below minimum temp error
Error messages
Extruder not hot enough/bedfans not a valid pin errors!
Solved
Macros
Error messages
Config
Klipper Screen wont load the network interface
Connectivity
Klipperscreen
Voron STM32_Mini12864 adapter gives error
Installation
Solved
uuid cant be found
Connectivity
Show Cursor didn't work?
Klipperscreen
Understanding Input Shaper results
Config
trying to set up fans as heaters.
Error messages
Macros
Config
cant flash klipper to spider board
Installation
Flashing
SOLVED updated klipper and sensorless homing stopped working.
Clicked update bttn
Unable to write tmc spi 'stepper_x' register DRV_CONF
Error messages
Cant get Katapult to work
Installation
Flashing
"Timer too close" at same point in a gcode file
Error messages
Pin 'gpio0' is not a valid pin name on mcu 'mcu' LDO Nighthawk Install 2.4
Installation
Error messages
Unknown sensor 'chamber'
Solved
Config
x and y not properly homing with sensorless homing
Meshing & probing
klipper mcu EBBCan: unable to connect
Error messages
slow print after cancel/restart
Solved
Macros
Config
klipper web interface loads on phone but not on macbook
Connectivity
MCU unable to connect
Error messages
Solved
Problem with G28
Config
LDO Nitehawk w/ neopixel
Config
"Move out of range" on print start (Z Axis -1.680)
Error messages
LED sleep
Config
Troubleshooting Z Axis Homing Issues
Installation
MCU 'mcu' shutdown: Timer too close when trying to print with ERCF
Error messages
MCU 'mcu' shutdown: Move queue overflow
Error messages
troodon mini, not quite solved but still done
Connectivity
Klipperscreen
pin out
Config
Timer too close?
Error messages
auto Z not working after update
Clicked update bttn
Nitehawk Toolhead Mounting points.
Installation
Solved