voron_2_help_forum_public
Voron 2.4 printed parts with a .6mm Nozzle?
Kits/parts advice
BTT Octopus on a 2.4
Electronics & wiring
Heating error during preheat
Printer shutdown
Electronics & wiring
Pattern on first layetr
First layer
I have a nidec Ultraflow fan, 12v and 2amp max not starting untill I reach 100%
Electronics & wiring
super bad resonances
Tuning
voron 2.4 350mm nozzle scrubber
Electronics & wiring
Configuration
Extreme Layershift Problems (Stepper do not have enough power)
Tuning
Electronics & wiring
Mechanical
Initial setup
Configuration
2.4r2 Nozzle begins to drag midway through first layer
Z Offset
Mechanical
First layer
Tap
Phaetus Dragonfly UHF Mount
Mechanical
Kits/parts advice
input shaper test isn't working
Tuning
Motor knocking on startup
Mechanical
Initial setup
Solved
Electronics & wiring
abs quality issues
Tuning
Extreme Bed Variance/Mesh Shape and First Layer Issues
Bed mesh issue
Mechanical
First layer
Serial request
Initial setup
Absolute Z +7mm
Z Offset
Solved
Configuration
z offset: position_endstop & probe offset
Z Offset
Initial setup
First layer
Pulley grub screws not on shaft flats
Mechanical
Initial setup
Solved
MCU errors on Voron with Manta M8P and CanBUS
Electronics & wiring
Printer shutdown
Initial setup
First print
Configuration
No UUID
Electronics & wiring
problem in zed movement.
Mechanical
Cant get EBB SB2209 into DFU mode
Electronics & wiring
Disassembling and Shipping a Voron 2.4
Kits/parts advice
Mechanical
Voron 2.4 Gantry Troubles
Mechanical
Eror line 13
Bed mesh issue
Voron 2.4 with Tap, unable to get first layer adhesion
Initial setup
First print
Bed plate installation
Initial setup
Linneo wiring harness pinout for X/Y endstop
Electronics & wiring
Hotend doesn't heat up anymore
Printer shutdown
Solved
Electronics & wiring
Need some help on correct fan.
Kits/parts advice
gaps in print
Tuning
Mechanical
Solved
V2.4 Tap R8 Belt Clip Shredding
Tap
how to cypher these graphs?
Tuning
Solved
Needs some help on the Hot End Build E-V/R6
Kits/parts advice
z_calibration issues
Initial setup
Flashing Fysetc Spider 1.1 fails
Electronics & wiring
Configuration
ESUN ABS+ fail
First print
Why so loud? Are the bearings shot?
Mechanical
Smoked a TCM2208 driver
Electronics & wiring
X and Y movement not working correctly after Z crash
Mechanical
Electronics & wiring
2.4r2 gantry Y axis rails spreading
Solved
Bed Mesh Issue
Bed mesh issue
2023 must have upgrades
Kits/parts advice
Co Print Chromaset + Voron Tap Compatability.
Kits/parts advice
Tap
What parts should I get for my voron 2.4 that have min/maxed value?
Kits/parts advice
Voron 2.4 Layer Shifting
Tuning
Mechanical
Printer shutdown
rough surface on top layer
Tuning
Bed mesh problems
Bed mesh issue
Nozzle scrapping the bed v2.4r2 with euclid probe
Z Offset
"Unable to read tmc uart 'stepper_z3' register IFCNT" error
Printer shutdown
Electronics & wiring