voron_2_help_forum_public
Changing Z-Offset has no effect on first layer after KAMP adaptive mesh
Bed mesh issue
Solved
liquids!!!!
Initial setup
Homing issues
Kits/parts advice
Configuration
Input Shaper Results
Tuning
What can cause this kind of mesh?
Bed mesh issue
Z Offset
Tuning
Octopus board issue
Electronics & wiring
None of my Endstops or Probe trigger
Configuration
Quad Gantry Leveling
QGL
Unable to read tmc uart 'stepper_x' register IFCNT
Initial setup
Voron 2.4r2 Z drift or inconsistent
Z Offset
Tap
QGL
Configuration
[Solved] Inductive probe accuracy
Bed mesh issue
Electronics & wiring
Mechanical
Z Offset
Configuration
Nozzle plugging prevantative ideas
Tuning
Configuration
Unable to open serial port: [Errno 2]
Initial setup
Configuration
Y-axis overshooting on every print move in which it changes direction
Mechanical
I want to understand how homing works on my Voron 2.4
Initial setup
Configuration
[SOLVED] Probe samples exceed samples_tolerance issue
QGL
z-layer shift after first layer ?
First layer
Initial setup
Nozzle dragging on infill
Tuning
Mechanical
Electronics & wiring
first print layer issues
Bed mesh issue
First layer
can't flash spider V3
Initial setup
Electronics & wiring
why is this happening?
Tuning
switchwire v6 Adaptation
Kits/parts advice
Mechanical
Electronics & wiring
Able to Extrude using web interface and purge line from config but does not extrude in prints
Mechanical
First print
config files Manta M8P v2
Configuration
manta m8p v2.0
Electronics & wiring
main softwear Voron 2.4
Initial setup
48v psu on octopus pro
Kits/parts advice
Electronics & wiring
LDO 2.4r2 Rev C Kit - BTT TFT Issue
Configuration
Layer Separation and Walls not sticking - Ellis SS ABS Profile
Tuning
Z offset & Klicky Probe - How to get consistent First Layer?
First layer
MCU 'mcu' shutdown: ADC out of rangeThis generally occurs when a heater temperature exceedsits con
Printer shutdown
voron 2.4 building endstop problem
Electronics & wiring
new build 600x600x600 build plate
Mechanical
[solved] ABS warping, Chamber Temp to low?
First layer
NeoPixel Refuses to work
Initial setup
Electronics & wiring
Configuration
Extreme ringing on my Voron 2.4
Mechanical
First layer inconsistency
First layer
Sudden layer problem
First layer
Hi, my 2.4 e3d revo does not heat up past 180 degrees and I get shocked touching it.
Printer shutdown
Electronics & wiring
Layers are not stacking properly
Tuning
300mm 2.4 LDO kit - X ,Y Squeak
Mechanical
Heated bed consistently throws 'not heating at expected rate' around 90c-100c
Printer shutdown
BELT TENSION WITH Klippain-SHAKETUNE
Mechanical
Klicky Probe Dock Too High
Mechanical
Solved
After print completed, gantry moved down and damaged print and nozzle
Initial setup
48V A/B motors
Electronics & wiring
Sourcing frame extrusions of proper grade alloy
Mechanical
Quad Gantry Level travel height to close to bed
Z Offset
First layer
First print
QGL
Configuration
Z endstop/Probe now always triggered - TAP and CAN2209 - RESOLVED
Configuration
canbus cable causing ripples on prints
Mechanical