voron_2_help_forum_public
Shake Tune Input shaper not making graph.
Tuning
Configuration
Z-axis steppers going "brrrr " during printing, x/y movement
Tuning
Unable to get "downstream" XXL Disco on a stick to light
Electronics & wiring
Configuration
dead board?
Mechanical
Weird artifacts after "upgrading" to Rapido UHF Hotend
Tuning
ssh fails, dozen reimages
Electronics & wiring
Wiring motor NEMA14 with EBB2209
Electronics & wiring
Extruder issues
Mechanical
Print defects
Tuning
First print
Problems with heatcreep above cold zone on revo
Mechanical
Electronics & wiring
Problems with perimeters in printing...? Not sure why...
Configuration
Premade Wiring loom has odd connections for the mainboard, where would these plug into?
Electronics & wiring
filament sensor
Initial setup
Klicky Probe as Endstop.
Z Offset
Initial setup
Configuration
hotend not heating at expected rate
Printer shutdown
How do I find renamed stls. Specifically looking for what superceded the old plug_panel.stl
Kits/parts advice
neopixel turns off at layer 4
Solved
Electronics & wiring
Help diagnosing a weird clicking / rubbing(?) noise
Mechanical
Home_xy_position in printer.cfg file has no effect on homing sequence
Configuration
BTT Octopus Pro v1.1 canbus
Electronics & wiring
Dragon HF low max VF
Tuning
Pressure Advance Calibration
Tuning
Bambu Labs Hotend In StealthBurner.
Configuration
Layer Shifts
Tuning
Mechanical
Solved
vibration problem
Tuning
Mechanical
Initial setup
Gantry stiff when hot
Mechanical
bad bed mesh
Bed mesh issue
hardware - Z_End_Stop, Magnetic Beds, Quad Gantry Level
Initial setup
Configuration
Klipper Updated, now mcu not connecting
Printer shutdown
Solved
Electronics & wiring
Configuration
Z offset completely broken
Z Offset
Z offset not reliable after every print
Mechanical
First layer
Print Issues
Tuning
Flash SKR 1.3
Configuration
/dev/serial/by-id : no such file or directory
Electronics & wiring
Very simple macro does not work
Bed mesh issue
Configuration
QGL
heater bed heats to a certain point then temp drops then starts climbing again
Electronics & wiring
new build - tool head slams into left gantry
Configuration
Unhandled exception during run PLEASE HELP
Mechanical
Solved
Configuration
is there a limit to the weight on top of a 2.4?
Mechanical
Diagnosing layer shift occurring mid-print
Mechanical
Electronics & wiring
Problem with bed heater
Mechanical
Printer shutdown
Electronics & wiring
Uneven Z axis movement
Mechanical
Z Offset
QGL
Quad Gantry Level Moving Off Print Bed
QGL
bed mesh not compensating
Bed mesh issue
First layer
Solved
QGL exceed sample tolerance.... sometimes !
QGL
Different surface quality
Tuning
48v upgrade V2.4 with 2x 5160h
Electronics & wiring
cable chains floating
Electronics & wiring
How to shove 625 bearing on the Shaft (Z-Drives)
Mechanical
Is this heat creep clog?
Tuning
Mechanical
Printer shutdown