voron_2_help_forum_public
Just a Voron rail hardware question
Mechanical
First layer inconsistency
First layer
Klicky Probe Install
Initial setup
Electronics & wiring
Configuration
bolts not long enough?
Kits/parts advice
Mechanical
Move Out of Range - initial config - Voron 2.4r2 rev c 300 LDO kit
Initial setup
LDO Z Stop/Probe Cable Confusion
Kits/parts advice
Solved
Electronics & wiring
Y-endstop squaring issues
Mechanical
Initial setup
Solved
Can't complete a print, need help to understand possible issues
Tuning
First print
Extruder issues and scratching the build plate.
Tuning
Initial setup
Configuration
PID Tune Heated Bed klipper shutdown and now no power in printer :(
Tuning
Initial setup
Electronics & wiring
Axial play in MGN12
Mechanical
Tap
Need help on new setup
Electronics & wiring
Initial setup
Printer shutdown
rattling in hot end, consistently inconsistent extrusions
Mechanical
first layer underextrusion
First layer
Solved
inconsistent layer stacking
Tuning
Mechanical
like many I am trying to enable bed mesh calibrate without errors
Bed mesh issue
Random layer shifts and shaketune mechanical issue
Mechanical
Chaoticlabs Tap Install on V2.4
Tap
Solved
Buildplate stinks, never printed abs or anything like that.
Mechanical
Initial setup
voron 2.4 running octopus and 5160 spi problems
Electronics & wiring
Weird lines on prints.
Mechanical
Nozzle ~5mm above build plate for first layer
Z Offset
First layer
Solved
Configuration
Corner Homing Macro
Tap
Solved
Configuration
QGL not working correctly after print
QGL
Quad Gantry Leveling values for a smaller size
QGL
Raspberry Pi Camera Woes
Electronics & wiring
Initial setup
Configuration
XY Rotational Distance Adjustment
Mechanical
Initial setup
lightweight mods or kits - Voron2.4
Kits/parts advice
Tap PCB
Solved
Electronics & wiring
Nozzle keeps clogging and causes underextrusion
Solved
Printer permanently stinks inside
Mechanical
Print cooling fan turns off Neo Pixels
Solved
Electronics & wiring
quad gantry leveling problems
Solved
QGL
Configuration
Help with V2.4 running Kraken and LDO Nitehawk
Printer shutdown
Electronics & wiring
Configuration
Stepper_x overtempwarning
Printer shutdown
Electronics & wiring
printer stopped working - Option 'serial' in section 'mcu' must be specified
Printer shutdown
Electronics & wiring
Can the blinking red led on the hartk afterburner pcb be disabled?
Electronics & wiring
Clogged Rapido
Mechanical
one motor does not energize
Electronics & wiring
cnc chaotic labs kit
Kits/parts advice
Mechanical
Issues with probe accuracy on QGL
Tap
Adjust position of bed in software [Solved]
Bed mesh issue
Configuration
Small artifacts on surface, look like extrusion problem.
Tuning
Rubbing/Vibrations causing horrible artifacts
Mechanical
BTT canbus install on klipper
Kits/parts advice
Initial setup
Galileo 2 random under extruding
Tuning
Mechanical
Configuration
Gantry shifts when homed to Z
Tuning
Mechanical
Z Offset
QGL
Configuration
NiteHawk-SB Neopixels Not working
Solved
Electronics & wiring
Configuration
left side of 2.4 gantry wants to sag out of random
Mechanical
Solved
Bad print quality
First print