voron_2_help_forum_public
carriage moving unexpectedly.
Mechanical
tap fried my pi
Tap
Electronics & wiring
IGUS Z Mount
Kits/parts advice
Mechanical
Electronics & wiring
Sanity check before I continue wiring it up.
Electronics & wiring
Orbiter 2.0 Stealthburner mounting options?
Mechanical
Hi, Im having trouble finding a list of parts I need to print.
Kits/parts advice
MCU 'mcu' shutdown: ADC out of range
Printer shutdown
RSP-200-24 PSU shuts down after a min or two
Solved
Printer shutdown
Initial setup
Electronics & wiring
Z ENDSTOP CALIBRATE issues
Bed mesh issue
Z Offset
QGL
Input Shaper Result Help
Tuning
Hotend temperature offset with ebb36
Electronics & wiring
Configuration
AB drives: B drive screech
Mechanical
Can I use ABS+ or ABS-CF filament to print parts for Voron 2.4?
Kits/parts advice
Poor bed level and first layer persists through multiple probe types
First layer
Stepper Motor Electrical Gremlin
Electronics & wiring
Stealthchop Resonance
Tuning
Mechanical
Leviathan + Rpi 5 + Chaoticlabz CNC Tap + Stealthburner/CW2 ( Voron 2.4 r2 RevC)
Initial setup
Electronics & wiring
Massive layer shift
Mechanical
Solved
Stealthburner RGB toolhead neopixels not working
Electronics & wiring
Belt tightening: Move gantry manually or with steppers?
Tuning
Mechanical
Solved
Formbot 2.4 reaches Chamber 33°C max
Tuning
Lots of probe undock fails after belt adjustment
Tuning
Mechanical
Solved
Configuration
Out of round hole
First print
Weird artifact/pattern in print as Z increases
Tuning
Mechanical
Solved
Voron with Chaoticlabs TAP
Tap
Strange Resonance Noise from Printhead
Mechanical
Really rough top surfaces
Tuning
Revo heater core fluctuating widly.
Printer shutdown
LEDs Wrong Color/Off Overnight
Solved
Electronics & wiring
Z=0 changes between prints
Z Offset
Mechanical
First layer
QGL
hotend not heating at expected rate
Printer shutdown
Electronics & wiring
bed issue.
Bed mesh issue
canbus board not turning on when chaoticlab cnc tap plugged in
Tap
Electronics & wiring
Configuration
new 2.4 build, terrible overhangs/bridging
Tuning
First print
Print cooling fan not spinning below 40% speed
Electronics & wiring
Klicky Probe Samples Exceed tolerance
Configuration
Resonance tuning / input shaping
Tuning
Printer hangs after heating
Configuration
Deracking
Mechanical
Solved
Discolored AB belts
Mechanical
moonraker connection
Configuration
Flow Calibration Problem
Tuning
First print
electrical gremlins ?
Electronics & wiring
Fresh bed mesh but looks like the corner dosnt compensate
Bed mesh issue
Z Offset
First layer
auto_z_calibration consistency
Tuning
Z Offset
Solved
Configuration
stripped nut housing
Mechanical
I am thinking that I had bed adhesion problem that popped off and caused a jam?
Tuning
Bed thermistor wrong reading
Tuning
Kits/parts advice
Configuration
Print head hitting printed item and sliding it around the build plate
Initial setup
Hi
Initial setup