build-help
Internal error on command:"PREP"
Initial Setup
[solved] bowden Calibration issue
Tuning
lane filament failed
Initial Setup
lane3 ejecting when it is unloaded in a print
Tuning
Not Switching lanes when printing
Tuning
Box-turtle brush clearance issue on my Voron 2.4.
Other
Biqu Nebula playing tug of war when filament should be switching....
Tuning
Build Issue
Other
[SOLVED] Using USB to Flash
Initial Setup
[solved] Unkown command: "TOOL=0" and Move out of range error when cutting filament.
Tuning
Initial Setup
Filament stuck when load filament
Build Issue
Initial Setup
I need help figuring out where to set up cut. park, poop and kick on a LDO Voron 2.4 Rev C.
Initial Setup
lane3 Current lane not loaded, LOAD TRIGGER NOT
Initial Setup
Extrude only move too long error.
Other
Buffer not doing anything
Initial Setup
unload cut and T0 - T3
Initial Setup
Start up wont get past first lane...
Other
Set BT Extruder motors to standby after print finishes
Tuning
remove SET_AFC_TOOLCHANGES
Initial Setup
afc_bowden_length
Initial Setup
Kick macro
Initial Setup
Disable Box Turtle for Single Larger 5kg Spool
Other
CALIBRATE_AFC LANE=1
Initial Setup
Inconsistent loading on 3 of 4 lanes
Tuning
Build Issue
Tool Start not working with SB2209 on GPIO21
Build Issue
lane2 failing to load consistently
Tuning
(Solved) Unload's failing
Tuning
Filament clogged/jammed in Rapido V1 Hotend
Build Issue
Initial Setup
Collision during filament cut
Tuning
Infinity Spool
Other
[solved]Unable to get "Trailing (Expanded)" status from TurtleNeck
Build Issue
[Resolved] BTIO drops USB connection to AFC-Lite ~1.5 hours into print
Other
Enclosure missing corner_cover_front.stl
Build Issue
Filament breaks in the PTFE tubes if left for a few days.
Other
Firmware Flashing via USB
Build Issue
Initial Setup
[Solved] Can’t install Klipper on AFC
Initial Setup
Possible solution for TTC errors and high Host CPU (Pi CPU) Usage
Tuning
Other
Lane 2 load failure during print only.
Tuning
[solved] Unable to flash AFC-Lite 1.1
Initial Setup
Poor quality finish on elements where there is a filament change
Tuning
[solved] Initial Setup Questions for Box Turtle & Trident 350
Initial Setup
ECAS-04 fits too tight
Build Issue
(solved) So completed the hardware part but have an upside down turtle :(
Initial Setup
respooler is my nightmare (LDO kit)
Initial Setup
[solved] Lane fails to pull filament
Initial Setup
Stuck on calibration Voron Trident
Tuning
laneX filament failed to trigger pre extruder gear toolhead sensor causing Timer too close error
Other
[solved] mcu 'Turtle_1': Unable to connect
Initial Setup
[solved] Issue with filament formed to a hook, prevent unload.
Tuning
Bowden tube diameter
Build Issue
Problem printing [a]_guidler_x4.stl
Build Issue