build-help
Nearly no retract on Filament Change (unload) from Printhead [solved]
Initial Setup
Extruder not config
Build Issue
Initial Setup
Loud whine when unloading Lane 1
Tuning
Build Issue
[solved] Respooler running backwards
Other
[Solved] Post extruder sensor issues
Tuning
[Solved] Lane unload no longer fast retracting
Tuning
Other
Turtle Neck issue
Other
Initial setup
Initial Setup
(Solved) Box Turtle Calibration Manual Parts
Build Issue
[Solved] Issue with first layer of purge tower
Tuning
Other
[solved] final calibration issue with two out of four tracks
Initial Setup
hub: direct
Initial Setup
[Solved] Filament calibrationation issue
Other
Unable to load filament on any lane.
Initial Setup
Problem with running out of filament and infinite spool not changing to new spool
Tuning
Other
Lane extruder filament sensor inconsistent
Tuning
Clogging in the upper part of the hotend
Initial Setup
[Solved] BT toolhead status confusion
Other
Filament Bypass from Amored Turtle AFC-Accessories: To much Bend in Pathway
Other
Tuning filament loading and running into a problem
Tuning
Canbus connector
Initial Setup
Extruder test
Other
pin_tool_start
Initial Setup
Intermittent respool issue
Other
Filament doesnt retract fully
Tuning
[Solved] Makes loud squeal and not retracting properly
Tuning
Other
[solved] mcu 'Turtle_1': Unable to connect - Was working fine
Other
Turtleneck not working
Initial Setup
Respooler speed
Tuning
Box Turtle and KAMP
Initial Setup
I have a problem with the cleaning nozzle
Initial Setup
[solved]BT Cereal (Printing in ABS) not heating bed correctly.
Tuning
Help with toolhead loading
Initial Setup
Tuning not successful, need guidance
Tuning
Where is it connected in the erb2.0 and in what open or closed mode?
Build Issue
Loading Reliability issues
Tuning
Initial Setup
Issue with one respooler
Other
Filament loading problem
Initial Setup
I need to reprint some parts, my BT isnt ready on any lanes. Can I bypass the TN and print?
Build Issue
Initial Setup
loading not possible as Extruder switch is not triggered
Tuning
Turtlenneck pro - LED not working
Initial Setup
Possible hotend filament binding??
Other
Hotend Setting in calibration process for BambuHotend
Initial Setup
New build BT won't push filament past the hub but it can definitely get there by hand.
Initial Setup
Ramming reliability and verification
Build Issue
Initial Setup
Drive gear wobble
Build Issue
Oozing after Filament Change
Initial Setup
{solved]Unable to read tmc uart 'lane2' register IFCNT
Initial Setup
[solved] I need help connecting all my htlf to my erb 2.0
Build Issue
Initial Setup
None of my lanes will load.
Initial Setup