build-help
[Solved] Retraction issues
Tuning
Gstat reset error (solved)
Other
afc_calibration problems
Tuning
Initial Setup
[SOLVED] Nighthawk-SB Toolhead Board question
Build Issue
[Solved] Spooler problem
Build Issue
[Solved] Are my motors trashed
Other
[SOLVED] Filametrix D2F Switch
Build Issue
(Solved) Shutdown while printing PLA
Build Issue
Other
[Solved] Toolhead Extruder Not Extruding?
Other
[SOLVED] Lane filament feeding issue
Tuning
"Runout triggered for lane lane1 and runout lane is not setup to switch to another lane"
Other
[Solved] SwitchSensor Jitter
Initial Setup
Other
disaster
Build Issue
[Solved] Filament reaching toolhead and keeps feeding.
Initial Setup
Lane 1 Issue [Solved]
Build Issue
Initial Setup
[Solved] New LDO Box Turtle setup and running into some issues with it.
Build Issue
Initial Setup
Looking for Steve Builds' exhaust Cover From His Recent Stream
Other
issues with tip forming
Tuning
TN-PRO/TURTLENECK V2 [SOLVED]
Initial Setup
[solved]Motor speeds question
Tuning
[SOLVED] Can’t get to the manual
Other
[SOLVED] Bowden Calibration infinite eject
Initial Setup
[Solved] Extruder Parts not fitting together.
Build Issue
Grinding on Load and Unload (Solved)
Tuning
Initial Setup
Middle Lanes unloading during print.
Tuning
Other
Filament Completely Ejecting During Tool Change - Solved - Bowden Length Too Long - Re-Ran Cal Mult
Tuning
[Solved] Fail to Load toolhead G2e issues
Tuning
Initial Setup
[SOLVED] Turtle_1 shutdown
Initial Setup
[RESOLVED] How to tell AFC Lite to look at printer MCU for filament sensor pin
Initial Setup
MCU unable to connect. First start
Initial Setup
AFC_CUT Move Out of Range Issues
Initial Setup
Other
[SOLVED] Spooler issues
Build Issue
[Solved] extruder shaft not staying in place
Build Issue
LOAD_FILAMENT Temperature Change
Tuning
Initial Setup
Solved: MCU keeps disconnecting.
Other
Isik n20 motors weak
Tuning
Build Issue
[SOLVED] PDF Manual?
Other
[Solved] Box Turtle Not following Extruder
Initial Setup
problem with lane2 loading
Initial Setup
Bowden Calibration Fails - Wont Stop Pushing - Similar issue to Johnjrk. - SOLVED
Initial Setup
[Solved] New Box Turtle Build
Initial Setup
Box Turtle wont turn up even though i pluged in my 24V
Initial Setup
[SOLVED] BT acting very weird the last 24 hours
Other
Stepper Motor Reports GSTAT error [solved]
Other
so i tried to change from usb to canbus [SOLVED]
Other
Timer too close error during spool changes
Tuning
Build Issue
Initial Setup
Other
Voron trident - Purge motion
Other
[Solved] Install and Calibration ( switching from HH to AFC)
Tuning
Build Issue
TMC 'extruder' reports error: GSTAT: 00000004 uv_cp=1(Undervoltage!)
Build Issue
BT Extruders limiting filament flow
Tuning
Other