build-help
[SOLVED] Buffer never compresses during print
Tuning
[SOLVED] Can you tell it to switch spools when one runs out?
Other
[SOLVED] Making CANbus harness
Initial Setup
Solved - ArmoredTurtle Brush
Other
[SOLVED]Internal error on command:"T0"
Other
[SOLVED] Filamatrix rapido 2.0 uhf mount
Other
AFC Stepper error
Other
Desiccant trays
Other
[SOLVED] Orcaslicer issue
Other
Box turtle extruder current
Tuning
Initial Setup
Other
[SOLVED] Start-code Makro Klipper
Other
Tight Tolerances
Tuning
Build Issue
Initial Setup
Other
(SOLVED) Question about filament temperatures
Tuning
attempting to get my first print going but having issues
Build Issue
Initial Setup
[SOLVED] Filamatrix cutter
Build Issue
Initial Setup
[SOLVED] Where to put Turtleneck?
Initial Setup
[SOLVED] Box turtle unloading past sensors
Tuning
[SOLVED] AFC-lite power delivery
Build Issue
Initial Setup
[Solved] Respoler no Respoler
Other
[SOLVED] spooler slow speed
Tuning
Lane stuck in loaded status, but is not loaded.
Initial Setup
[SOLVED] Load Issue - Jamming Before Pre-Switch
Tuning
Other
[SOLVED] Why PLA if ABS is the default?
Other
[SOLVED] Any Issue Changing Orientation of Extruders??
Other
[SOLVED] Potential Motor Issue (Sounds Stressed?)
Tuning
Build Issue
[SOLVED] Afc lite pin is not valid
Initial Setup
Just put this together and having a tough time
Initial Setup
lightbox print settings help
Build Issue
[SOLVED] Filametrix
Build Issue
Somewhere in the middle of my last print things got really funky with Lane2 (solved)
Tuning
Build Issue
Tight spooler wheel drives
Build Issue
[SOLVED] Filament being sent back faster than heavy spool can wind.
Tuning
[SOLVED] Turtle neck slider causing filament jam
Other
[Solved] BoxTurtle Lane Extruder is grinding the filament
Tuning
Toolhead won't retract at end of print and then hub isn't empty.(SOLVED)
Tuning
Other
Can Bridge mode
Other
[SOLVED] BoxTurtle Calibration Fidget
Build Issue
(solved?) internal error on command t1
Other
[SOLVED] Lost connection with mcu. help.
Build Issue
[SOLVED] Should I use single switch or dual switch clockworks2 main body for filamATrix?
Initial Setup
Need help with initial setup after build and wiring
Initial Setup
shuts down with MCU error
Build Issue
Poop zhop something is off
Tuning
Other
[SOLVED] Re-spooler motor very weak
Tuning
Other
[SOLVED] Bypass setup issue and questions
Other
spoolers unwind the coil, turtle neck often works
Initial Setup
Respoolers, LEDs and fan not turning on anymore
Other
[SOLVED] bowden diameters and initial tuning
Initial Setup
TurtlePulseCore Lane 4 Gstat Error
Tuning
Build Issue
Initial Setup
Other
(Solved) Lane change filament temp.
Initial Setup