build-help
Lane/tool swap retracts too far
Tuning
Any way to waste less filament with infinite spool?
Initial Setup
Turtle buffer always in Advance(expanded)
Tuning
Build Issue
Initial Setup
Can bus wiring
Build Issue
[SOLVED] Filamatrix not able to cut.
Tuning
Bypass mode questions
Tuning
Attaching wheels
Build Issue
How to get Orca slicer to change temps before filament change?
Initial Setup
how much to set variable retract in filament cutter macro?
Tuning
Flashing Klipper via Katapult
Initial Setup
Error updating AFC Klipper firmware
Initial Setup
[SOLVED] How to get poop to stick to bed?
Tuning
Respooler is unspooling faster than extruder is advancing filament
Tuning
Initial Setup
[SOLVED] Move exceeds maximum extrusion
Tuning
[SOLVED] Filamatrix d2f switch
Build Issue
Weird Skipping movement
Initial Setup
[SOLVED] Pin 'Unknown' is not a valid pin name on mcu 'mcu'
Initial Setup
Wire gage
Other
[SOLVED] AFC lite bricked?
Build Issue
Lane 3 spoolers not keeping up on unload
Build Issue
Start Gcode help
Initial Setup
Quad Gantry Level error after BT installation
Initial Setup
[SOLVED] Configuration
Initial Setup
IS there anyone willing to check over my build and tune it?
Other
Preparing for a BoxTurtle build
Initial Setup
Other
Prepping Enderwire for Box Turtle.
Initial Setup
Help with ebb canbus
Tuning
Initial Setup
Other
[SOLVED] filament coil problem
Initial Setup
[SOLVED] dizzy
Tuning
No clue what happened. (SOLVED)
Other
[SOLVED] AFC Fan control speed?
Other
Filament Roll size
Tuning
Other
Loud sound after jam [solved]
Other
[SOLVED] AFC_CUT movement out of range
Initial Setup
[SOLVED] Calibrate a Hub Cutter
Tuning
filament change
Initial Setup
[SOLVED] Filament getting stuck in 4-1 hub?
Tuning
Other
[SOLVED] Help with error when loading lane
Other
[SOLVED] How to disable spoolers
Other
(SOLVED) Nozzle leaking during filament swaps help
Tuning
extrude distance error [solved]
Other
(SOLVED) g2e cutter issues
Tuning
[SOLVED] Print fails after first filament change despite successful poop
Initial Setup
Internal error on command:"PREP"; and T[x] still mapping to T[x+1]
Other
[Solved] Extrude only move too long
Tuning
Lane 1 load issue
Tuning
Stealthburner Filament Entry Sensor Switch for Box Turtle [Solved]
Build Issue
Filament loaded in bypass, not doing tool load
Initial Setup
[Solved] Wiring Hotend Filament Sensor Switch
Build Issue
[SOLVED] AFC turtle.cfg
Initial Setup