fallen yoke
Hello Guys, I'm struggling with overhangs on H2D. I have no warping issues. I have already wasted/testes one roll, but still have some problems. I think I'm quite close to the perfect print, but I'm a bit stuck what to change. I have calibrated the material, I made a lot of changes with the temperatures. I slowed down to very minimum, but after a while i have no improvement. I read the fans should be turned off, but I think that should be the next step. What do you think? Does anyone have a H2D profile? <@&1122587817768398938> thanks in advance.
uncut ridge
fading granite