young needle
<@&1122587817768398938> I have had this issue for the past 3 months and can’t find a solution. Whenever I try printing something it comes out spongy and can be crushed in your hand. I have tried changing extrusion multiplier (using the extruded 100mm method) changing temp, filament, cleaning bed everything I can think of. I use a anycubic Kobra Neo using prusaslicer. Here are pics if someone can walk me step by step that would be amazing.
robust token
Looks like silk filament?
teal orbit
Under extrusion maybe
robust token
But looks like you have a nozzle clog.
Or your filament is wet?
young needle
It’s anycubic branded pla and it’s from a new roll. I have also changed the nozzle twice
robust token
How are you uploading the file to the printer?
young needle
Downloading the file to an sd card
robust token
Downloading the file to an sd card
Assumed much, the SD card has most likey gone bad.
young needle
Assumed much, the SD card has most likey gone bad.
That can happen I didn’t know that
I’ll check if I have another sd card somewhere
But I gotta get to class
robust token
That can happen I didn’t know that
yes. SD cards have limited read and writes and also cheap SD cards are just crap and will fail on you
young needle
Okay found a new one will test out later
robust token
Okay found a new one will test out later
good luck
young needle
Thank you 🙏🏻
