<@&1122587817768398938> looking for help setting up this filament. I get a lot of stringing and blobs. Tried doing a temp tower last night and it looks like the temp should be 260 which feels high to me. Anyone have any suggestions on the basics for this filament in this printer?
#PolyLite PETG translucent red profile for X1c
queen oracle
signal hearth
<@&1122587817768398938> looking for help setting up this filament. I get a lot ...
Hey, I usually print PETG at 265-270 and 60C
The last temp tower I did with it had 270 being the best quality and I ended up with a deeper color the higher I went up in temps which I found intriguing. You may need to dial in the fan for bridging though
obtuse drum
How long ago did you dry it? Temps are very dependent on speed, I wouldn't worry about that too much just run what looks best
queen oracle
How long ago did you dry it? Temps are very dependent on speed, I wouldn't worry...
I dried it in my polymaker dryer for 6 hours until it was down to 10% humidity and immediately ran the temp tower.
queen oracle
The last temp tower I did with it had 270 being the best quality and I ended up ...
More or less fan speed for bridging? What about the blobs of filament on the print?