wispy estuary
All my prints have stopped working lately and cannot get past a good first layer. After a few layers filament stops extruding but print continues moving. I'm printing in normal PLA, I tried different spools none work. I've been using a .4mm not sure if it's the nozzle.
<@&1122587817768398938> I would appreciate some advice
meager crystal
are you printing with the door and lid shut?
it could also be a partial clog in the nozzle too have you tried a different nozzle?
wispy estuary
are you printing with the door and lid shut?
Yeah, both are shut while printing
I'll trying using a different nozzle and see how it goes
wispy estuary
it could also be a partial clog in the nozzle too have you tried a different noz...
That was it! After swapping out the nozzle I accidently put lube on instead of thermal grease... But after fixing that it's back to printing. I'll probably look for a way to unclog it next.
Anyways, thank you for your help