CosPLA underextrusion issue | Polymaker (3D Printing) | Page 1

obtuse vale Dec 19, 2023, 3:59 PM

#

So I am trying out the CosPLA. I am having an issue with it currently. I have a new nozzle and don't have any clogs. I was running the hot end at 220 and the bed at 60. I adjusted the retraction rate to 3. I'm not sure where my issues is.

agile saffron Dec 19, 2023, 5:38 PM

#

obtuse vale So I am trying out the CosPLA. I am having an issue with it currently. I have a ...

Have you tried changing the nozzle or maybe a cold pull? It may be a partial clog?

obtuse vale Dec 19, 2023, 5:47 PM

#

I've done both so far. I was using cura to slice the file in the image above.

#CosPLA underextrusion issue