Hello everyone I recently buy 500g of pa6-gf and I got surprised when I noticed that the filament was weak like a wet PLA, cause I’m having a bit of issues with it so I would like to know if yours are too (sorry for my bad english)
#Is my PA6-GF wet or not
buoyant gorge
fading anvil
Unless you’ve dried it (100C for 8 hours as recommended by Polymaker’s product page for PA6-GF) and immediately put it in a dry box, chances are it’s wet.
I had issues with PA6-CF layers delaminating that disappeared as soon as I dried and stored it properly
buoyant gorge
I had issues with PA6-CF layers delaminating that disappeared as soon as I dried...
oh ok thank you also i have a lot of issue with stringing, its like the filament its melting all the time even if i put it on the minimal constructor temp (280°) do you have any suggest ?*
native path
Pa6 wet yes sure it is. I open it consume it. ASA TPU same use it or dry it before second use
ashen delta
Even straight out of a brand new package it can be wet. Always dry your nylons