Recommended print settings for CoPA for bambu slicer? Printing on bambu x1c with ams.
Also will the provided engineering plate be good enough for this material?
#polyamide CoPA
uncut knoll
frail prawn
Just about any plate should work. Grab one of the PA-CF profiles that were uploaded and start there. You should only have to make minor adjustments after that.
icy ravine
Use an interface layer like gluestick to avoid damaging your pei.
uncut knoll
Just about any plate should work. Grab one of the PA-CF profiles that were uploa...
cool, thanks
uncut knoll
Use an interface layer like gluestick to avoid damaging your pei.
thanks
rapid bolt
Any idea how to get the shiny gloss off CoPA-prints? on the website the look rather matt. thanks.
rapid bolt
Use an interface layer like gluestick to avoid damaging your pei.
So far I only did some 30/30 Voron-test cubes, but I have absolutely no adhesion issues. after some minutes of cooling (plate temp=50°C) It pops off almost without touching. Black original Bambu- doublesided PEI sheet.
radiant talon
Recommended print settings for CoPA for bambu slicer? Printing on bambu x1c with...
Hey mate, was wondering have you been able to dial in a profile for the CoPA for the X1C?
uncut knoll
Perform the temp towers, flow extrusions and other calibrations, that will be a good starting point, you can also use the spec sheet given by polymaker.
radiant talon
Perform the temp towers, flow extrusions and other calibrations, that will be a ...
Thank you! Did you find a good Volumetric Flow rate to start on?
wraith spire
Bed 40c
Nozzle 245
Speed
First layer 25mm/s
Owall 40 mm/s
All the rest 60mm/s
Raft 15mn
If you have .4 Nozzle keep all your extrusions at .42 to avoid stress that will cause warping.
Dry you filament for 6 hours at 100c. Do it.
Glue stick
Happy printing