Temp Tower - Flow Rate - Pressure Advance---- What to do first?

[austere pewter]

I'm having some challenges with my PETG since I replaced my nozzle. What order should I be running these calibrations. Which is first?
Chicken or the Egg???

[amber spear]

Temperature tower first -> then you get the temperature
Flow Rate second with the temperature your found on the previous test
Then pressure advance.

(but it depends on how you run all of these tests, but generally thats the order I would do 🙂 )

[austere pewter]

Thank you... Off to print my temp tower.. That's what I thought but just needed a little noobie confirmation...

[late light]

This is the best tuning guide around, written by one of the Voron Devs. Follow his guide in order and your prints will be flawless. https://ellis3dp.com/Print-Tuning-Guide/

[austere pewter]

Have you applied this to calibrate your X1C?

[late light]

I have not, but this is the guide I use with all of my other printers. The addition of pressure advance tuning for the bambu was fairly recent. While I could do this, my issue is less the need to, more that I'm apparently the only one that needs to. If I paid for the lidar and camera and self calibration, I want to have it work.

[austere pewter]

Agree.. Don't want to get into that lidar rabbit hole discussion... 😉 I feel the same way but in the meantime.....