polar veldt
Does anyone use an infrared thermomter to check for hot/cold spots on their printer bed? I'm printing small parts and having some first layer issues where it starts in the corner of my bed. No issues when I print a single test part. This is a new roll of Silver PETG so I'm drying right now to see if that helps. Also had no issues with printing Red PETG.
bitter olive
Does anyone use an infrared thermomter to check for hot/cold spots on their prin...
Yes I have, that’s how I proved to Anycubic their hot-bed was defective and not my mistake. A laser instant thermometer is a must for any tool box. 👍 and they are cheap but effective.