TPU95 Profile for Bambu X1C | Polymaker (3D Printing) | Page 1

tame bane Jan 8, 2023, 5:22 PM

#

Does anyone has a good Polymaker TPU95 profile for the X1C? I'm having difficulties to print it even after drying.

ripe lava Jan 8, 2023, 5:23 PM

#

Maybe better to post this in #1046054303581876254 ?

tame bane Jan 9, 2023, 4:25 PM

#

Finally, I did some tests and my problem was the max volumetric speed was too high at 6. I lowered it at 3 and it worked flawlessly.

weak pond Jan 12, 2023, 3:52 AM

#

We're printing batches with TPU90 on our X1C with very good results.

The most difficult part is spool changes where the printer can fail to load the new filament properly (not using AMS).

cloud burrow Jan 13, 2023, 5:52 PM

#

I'm getting ready to print some BL TPU for the first time. Does anyone have a comparison between BL's TPU and Polymaker TPU. And is there a benefit to using the HT TPU? I have both X1C and P1P.

weak pond Jan 18, 2023, 1:34 AM

#

We have some BL TPU but haven't printed with it yet. We've used Fiberology 30D too but found Polymaker TPU90 a better balance of consistency and soft TPU. We're getting very consistent printing performance and few clogs while in use.

The only times we have trouble is on spool changes mid-print which our X1C does not handle as well as our Prusas.

still sorrel Apr 7, 2023, 9:32 PM

#

tame bane Does anyone has a good Polymaker TPU95 profile for the X1C? I'm having difficult...

@tame bane what settings did you ultimately settle on? I started with the Bambu TPU profile and got a TON of stringing. at the point i have the print temp at 205 and retraction at 7mm and 50mm/s with only very minor improvement :/

harsh moth Apr 7, 2023, 11:41 PM

#

tame bane Finally, I did some tests and my problem was the max volumetric speed was too hi...

Yes can you please share your profile?

tame bane Apr 8, 2023, 4:27 AM

#

harsh moth Yes can you please share your profile?

Always ensure that your filament is dried correctly.