#Cables not transferring electricity
1 messages · Page 1 of 1 (latest)
Any red dots on the extenders?
Nope
Hmm
Cables only transfer power when there's a draw on the run. When not pulling current, they're dormant. Make sure you have them connected to something that draws power, but connect them directly as a test. If they're too far away, test each one with an extender. Also, the generator of your choice has to be in working condition, or it won't transfer power. Hope this helps.
I have connected them to a destination, didn't work.
Will try connecting them directly.
All are in tip tip shape.
Will report back. Thank you!
Didn't work.
I would need to see the entire setup to determine what's happening. Any chance you can get a wide-angle shot and show me to what, and where, the lines go?
Going to try a restart and see if that fixes it.
when you say 'destination', you're not talking about a wall plug are you? those are just wall pass-through ports. you have to hook up directly to the panel. just wanna make sure that isn't the case here...
That was the case. I'm stupid, ha.
its all good. it has caught a few folks off-guard lol.
While you're here, any idea how to open the door at this location? Don't see any switches anywhere.
i know where you're at lol. maybe take a glance underneath the building 😉
in the water
oof... havent been confident enough to dip into the water, but I'll give it a go, haha. Thanks again!