#Just to confirm post VRC Build 1289

1 messages · Page 1 of 1 (latest)

brave hinge
#

Hey GoGo Loco Team,
I just want to confirm that post this update are there any changes to the install process or resets that need to be done to ensure it works properly again?

So for the manual installation and the VRC Fury method as well. I only ask because my avatars feet fold into themselves when I’m too close to the ground at least on desktop so far. I have not tested this on full body or half body.

I did also add an EMPTY avatar mask to the entirety of the body on all of my FX layer that might be causing the issue too so I just wanna make sure you don’t need to say, delete the clone folders and things like that, in order for it to install properly.

autumn pecan
#

It should work normally now on any installation.
adding Empty Avatar Masks are not that bad if they are used correctly ^^ (For WD OFF you should use Masks)
If your Avatar is using WD ON you should remove the masks again and if there is still a problem then something is wrong on the avatar. (Don't merge Base/Action/Gesture Layers...)

so if you upload with VRCFury you should only have your FX Layer from the avatar in and nothing else in the Layers

brave hinge
autumn pecan
brave hinge
#

Okay, I'll give it a go with the hand gestures layer off as well and if it works I'll manually put the hand gesture animations in along with the rest of GoGo Loco instead of using VRC Fury just to be sure.

spare ice
#

@autumn pecan the vrcfury method does not include the gesture controller, since it often conflicts and doesn't bring much benefit.

brave hinge