Motors help

[sharp wigeon]

That's normal if you don't have the propellers installed

[keen thunder]

Even with propellers

[sharp wigeon]

In that case, something is spinning in a way it's not supposed to. Check the motor order, direction, and prop installation.

[keen thunder]

I noticed that this problem only happens when I use my radio

[sharp wigeon]

That is also expected. Arming it runs the full flight control loop while manually moving the sliders just sends static throttle values to the ESC

[keen thunder]

in the motors section everything is ok

So i dont know what Is the problem

[keen thunder]

😭 what can i do?

[keen thunder]

I even tried to reflash the firmware😭😭😭

and when I'm in acro it doesn't happen

[sharp wigeon]

Something is not correct if it happens with the props on. Re-check the things I listed, and try https://www.youtube.com/watch?v=H0wFSTdpIWM

[keen thunder]

Nothing

and with the air mode the angle gets worse and it starts to give problems even in acro

[sharp wigeon]

Is that with the props on or not?

[keen thunder]

both

With and without

[sharp wigeon]

I would like to see what happens with the props on outside

[keen thunder]

But the problem isn't the propellers. When I increase the throttle slightly, the engines increase and decrease on their own.

[sharp wigeon]

That is normal if the propellers aren't installed

[keen thunder]

I tried withe the props outside but nothing change