Foxeer M10Q Magnetometer not working

[opal frigate]

Hey, I'm trying to troubleshoot an issue with someone who has a Magnetometer that doesn't work in Betaflight.

Things we've tried already:

• Firmware is flashed with USE_MAG and USE_MAG_QMC5883 defines
• Magnetometer is turned on in Configuration tab
• Tried I2C address 0 (the default) and 13 (as per documentation for that chip)
• Tried I2C device 1 and 2

Any suggestions?

[sharp remnant]

Do not enter MAG_QMC5883. Post a !supportid

[vestal talon]

Betaflight Support

Submit Support Data

1. Open the CLI tab
2. Click the "Submit Support Data" button

• Optionally enter a brief description of the problem
• Wait for it to finish

3. Copy the resulting support ID

Check the image below for visual steps:

[opal frigate]

Id: "f804d727-59b2-4e07-b349-11004fffe53c"

[sharp remnant]

Config looks fine. Set Motor Protocol to DSHOT300, then try setting the mag hardware manually:

save```

[opal frigate]

Tried that, nothing

[sharp remnant]

There should not be an I2C address conflict, but you can try changing the I2C address by bridging these pads:

[opal frigate]

Hmm, but then the baro will be on another address?

I'l tell him to try that, again, not my board and I don't have it physically with me

[dim basin]

i have the same gps

magnewtometer alligns best when outside

[opal frigate]

This has nothing to do. The mag isn't even being picked up by betaflight

[dim basin]

Oh is it

Just like

Yeah

Ygm