Tinyhawk going elrs

[ornate furnace]

I have a tinyhawk 2 freestyle and the crappy radio died. I have a radiomaster tx15 and soldered an elrs reciever in the hawk. In betaflight everything connects and controls seem fine but in RL only the right stick makes the motors spin 2 at a time and throttle does nothing. Any help would be greatly appreciated

[austere nymph]

Sounds like it may be in "flip over after crash" mode

[somber loom]

#798006228450017290 message

[ornate furnace]

I deactivated that mode and now no motors turn. Lol. So there's one problem gone.

[somber loom]

what arming disabled flags show up now?

[ornate furnace]

Okay, I found a way to finally update firmware. I did that, then it lost all gyro, functionalities, and
Accelerometer, so I rolled back to an older firmware but substantially newer than what was on there. Everything seems to work right, except
My control functions. I see everything in Beta. Flight working with my radio I can test the motors in Beta flight. They respond perfectly when I disconnect from Beta flight, my radio connects to my receiver. I can see the board led flashing to my switches, according to my radio. But no functionality even the beeper flashes but no beeps.

[ornate furnace]

@austere nymph it was, thank you, but it wasn't responding to my switches. So I removed all modes besides arm

[ornate furnace]

@somber loom I'll check that this afternoon. Hopefully that gives me the answer I'm looking for. Thank you. I'll let you know what I find.

[ornate furnace]

@somber loom rpm filtering

[somber loom]

try without bidirection dshot in motor tab

or flash the esc with bluejay if you haven't yet

(though if you already have, you shouldn't be having this flag)

[ornate furnace]

It works with Bidirectional shot off. Im not 100% sure if the TH freestyle 2 can hande Bd dshot. But it seems to work with it off. Now I just need to try and fly it maybe tomorrow and see if it can take off. Thank you

Im not sure what blue jay is. Is it similar to betaflight or is it a FW?

[somber loom]

it's an esc firmware with bidirectional dshot support

[ornate furnace]

@somber loom oh, so will that help or will it be more battery efficient

[somber loom]

bidirectional dshot is needed if you want to have rpm filtering, which will help with motor noise filtering, which in turn lets you have much fewer filters for the gyro, which then gives you much lower delay on your drone's reaction

[ornate furnace]

So would you recommend me flash blue Jay then?

I asked Google and he pointed me towards Oscar Liang s instructions I'll give it a go tomorrow and report back. Thanks for the idea