drowsy carbon
does anyone know how to fix erratic behavior on the receiver tab? Whenever I bind my radio, the drone in the receiver tab starts to spin in circles. Every switch registers through Betaflight, but the sticks do not. I have a radiomaster pocket ELRS and a speedyBee Nano 2.4G ExpressLRS.
primal scarab
Hi! Could you explain the problem in a little more detail:
As solutions from personal experience I can suggest to check first trimmers! If they are not disabled, then you could accidentally touch. Send a photo from the home menu of the remote.
Secondly, in betaflight, the channel map may be confused. For example, gas and yaw are swapped.
Thirdly, there may be something with the channel settings in the remote.
and fourthly, maybe the sticks are just badly calibrated)
high light
make sure channel mapping in the receiver tab is AETR1234
drowsy carbon
Hi! Could you explain the problem in a little more detail:
As solutions from per...
Thank you for helping me, but did you want the picture of the Radio home menu?
drowsy carbon
make sure channel mapping in the receiver tab is AETR1234
I tried this already and it didnt work sadly...
primal scarab
Thank you for helping me, but did you want the picture of the Radio home menu?
Hi! Yes, could you send me a photo like this (from this menu)? Pay attention to the highlighted areas, which are the trimmers. As my experience shows, this is often the cause of the problem you described.
primal scarab
Thank you for helping me, but did you want the picture of the Radio home menu?
It is also a good idea to pay attention to the channel mixer to confirm or deny your suspicions that your equipment is not properly configured.
drowsy carbon
drowsy carbon
@primal scarab 🙏🙏
primal scarab
<@1234592478846259334> 🙏🙏
Hi! Sorry I'm so late. Yeah! I see you have some strong trim settings on your main screen, one of them is for yaw!
What's your remote model, I need to know to fix it!
primal scarab
Okay, if I've correctly identified your controller model, it's the Radiomaster Pocket.
The issue is that your trimmers are tilted. Trimmers are like a software-based tilt of the trimmers, as if you've already tilted the stick, but it's actually in its original position. This needs to be corrected. I've marked the control responsible for this setting in the images. Its axes correspond to the axes on regular sticks. You need to align these trimmers so that the square is in the center and there are two sticks inside it (I hope I explained it clearly xD)
In fact, trimmers are almost never used on quads, so let's remove them completely so that you can't accidentally reject them again.
To do this, press MDL and then PAGE> until you find the INPUTS section. Here are your control channels (Roll, Pitch, Throttle, and Yaw), press the drum once to display the settings menu. Look for Trims and set it to OFF. Repeat this process for each control channel.
Your trimmers are now disabled, but keep in mind that we only changed this on one of the models. When you create a new model, the settings will be default
