Missing OSD Elements when Updating Darwin Foldape 4 from 4.4.2 to 4.5.2

[simple yew]

I'm trying to update my foldape from the stock firmware (4.4.2) to 4.5 to set up GPS rescue. I'm currently setting up the OSD and I noticed that no GPS-related elements are showing up. Some other elements also aren't visible or are behaving incorrectly:

-VTX Channel is showing up as ?:?:200.
-Battery current draw and battery current mAh drawn are showing implausibly high values (1 kW+ power draw at idle)

These were working correctly in 4.4.2. There are other elements that don't seem to work but they weren't part of my OSD before.

Looking at the diff of the backup vs the new config, there were a lot of dma commands in the backup that don't seem to have a matching value in the new config. My suspicion is that these could be related, but I haven't been able to find any resources describing what they do.

Side note: there are also a lot of values in #master and #profile that are different in the new config. Is there a list of which ones are safe/recommended to carry over?

[grand wind]

Hey! We think our bot can help with your question; click the button below to generate an answer.
Please also give us a support ID

1. Open the CLI tab
2. Click the "Submit Support Data" button
3. Optionally enter a brief description of the problem
4. Wait for it to finish
5. Copy the resulting support ID
6. Paste it here

{'cause': 'thread creation'}

[simple yew]

b98bd69c-11de-462f-aae9-9671489d8a7f