winged scarab
Hi, i have a Nexa 3.5 EVO Pro 04. i stupidly changed the uart after a few flights to check something. i didn't change anything else. Since i reset the settings, my drone can't find my controller anymore. what could be the reason? i reconnected it and set it to number 6. what could i have done wrong? Kind regards
gleaming kettleBOT
Hi, i have a Nexa 3.5 EVO Pro 04. i stupidly changed the uart after a few flight...
After resetting settings, the UART configuration likely reverted to defaults. Please double-check that you have configured the correct UART for your receiver in the Ports tab, and that the receiver configuration is properly set in the Configuration tab. Consult the Setup Guide and Ports Tab and Configuration Tab documentation for more information. If you need further help, please ask in #1052457584772255784.
winged scarab
didnt work
true hazel
Hi, i have a Nexa 3.5 EVO Pro 04. i stupidly changed the uart after a few flight...
you didn't saved a config backup before you braved out changing something on the config?
uart 6 should be for the MSP and Displayport
what receiver does it have?
i.e. instead of enabling MSP and setting Displayport-MSP in UART4, set it to UART6
if you're using the dji controller for it, then Serial RX should be enabled on UART1 instead, not UART6 (I think. based from the pad arrangement here)
winged scarab
bro you are my hero 😗
winged scarab
My goggle is not showing voltage and generally the settings I make are not showing on my screen. I have OSD settings on and also see 0.0 volts and other settings, but not the settings I have made. What could be the reason for this? What could be the reason?
true hazel
My goggle is not showing voltage and generally the settings I make are not showi...
can you post a screenshot of the Ports Tab, particularly that last column for UART6 please..
Did you set your goggles to use "Custom OSD" or something like that (Canvas Mode, etc).
(I don't have a dji fpv system here so I'm not really that familiar with each of the options)
winged scarab
i'll send you a few screenshots. i also want to switch to tbs crossfire. but the controller won't arrive for another 10 days... but you can still have a look at the settings until then
winged scarab
.
.
.
.
btw do you have good frestyle rates for a 3,5” copter so the Nexa 3,3 evo pro?
and for cinematic flights rates for the cinebot 30 (i film realestate videos (i am a real estate agent))
just in case you have any tips
NEXA 3,5 EVO
true hazel
so none of these show up on the goggles OSD? you already have enabled "Canvas Mode" on the goggles?
