Hi,Can anyone help me? My FC cannot be used after hijacking DFU. After reading several forums and trying the steps given, I finally managed to enter recovery mode Bootloader but it becomes a problem when the firmware flash is not successful. I have included some pictures for reference. When the USB cable is connected to the FC there is no sign of connection except when Press the boot button and can connect DFU STM32 bootloader but failed to flash firmware.The FC only lights up red when the USB cable is connected.I'm stuck, hope someone can help.TQ
#Fc cannot be flash firmware after Hijacking DFU
33 messages · Page 1 of 1 (latest)
Do used impulserc ?
Yes,I used zadig and impulseRC and it didn't work either. I even tried STM32cubeprogrammer but it didn't work.
What Betaflight version are you trying to flash?
You should be using https://app.betaflight.com/
Configuration and management tool for the Betaflight flight control firmware
Show a screenshot of Windows device manager with the FC plugged in, and in DFU mode
I have tried too but it didn't work.
I used this too but still no success https://app.betaflight.com/
Configuration and management tool for the Betaflight flight control firmware
Do you choose board and version fimwere?
Yes...before this there was no problem but after the DFU hijacking happened, it kept happening like this. I'm not even sure how the DFU hijacking could happen.
I think :
-Either the target is incorrect
Or dfu was not correct
Is anything connected to the FC?
I'm not sure but when the usb is connected, only the red light comes on without blinking.
I have tried using 3 different laptops and cables, but it's still the same.There have been no problems before.
Take a clear photo of both sides of the FC
You might need to remove power or connections from any device on a uart. I've got one drone where I have to unplug the Vista to get it to flash, I have another one I have to unplug the GPS.
Or just unpower those accessories but removing just thier power +
I have removed all the wires and still have the same problem.
Initially I followed this method and was able to enter the DFU bootloader but was unable to flash the firmware.
Are you selecting the correct firmware? Show a screenshot of the firmware flasher after clicking "load firmware" but before clicking "flash"
does the top of the configurator say its connected to the device "DFU..." or "Bootloader"?
that looks ready to go. just need to manually select your Target Firmware of... What is it again? do you have the backup from it?
something like this
Yes...I have tried this method many times but it didn't work.
Can you try another computer or chromebook?
https://hackmd.io/@nerdCopter/rJv5TUrQ2
read in here and see if anything helps your situation 🤷♂️
Ive seen the "Guillemot" driver under game controllers in Device manager interfere before
HackMD
recommend latest nightly configurator rather than 10.9 release. https://github.com/betaflight/betaflight-configurator-nightlies/releases
I will try and update. Thank you.
Desolder the Rx and all other serial devices
I did it but still can't