#Reset CLI from GEPRC Website put ELRS Receiver Into Bootloader Mode.

1 messages · Page 1 of 1 (latest)

waxen musk
#

Hello, I wanted to revert my Cinelog 20 PIDs and Rates to stock so I input a stock CLI from the GEPRC website. Prior to this I was having no issues connecting to my receiver. Not sure why this has put the receiver into bootloader mode (Static Blue LED) or how to fix it without taking it apart.

meager chasm
#

Did you save a backup before applying the stock CLI?

#

Is your receiver protocol set to CRSF on the receiver tab in Betaflight?

waxen musk
#

I unfortunately did not save a backup, yes it is set to CRSF.

#

when setting it to SBUS the drone is connecting to my DJI Controller

meager chasm
#

If the SBUS wire is connected then the ELRS receiver will go into bootloader mode

#

Remove the SBUS wire from the VTX, or move the ELRS receiver to a different UART

#

And always save backups!

waxen musk
#

Ok thankyou, I will haha! But what confuses me is that it was working before even though the sbus wire is still connected.

meager chasm
#

What FC do you have?

#

Can you post a !supportid

kind etherBOT
#
Betaflight Support
Submit Support Data
  1. Open the CLI tab
  2. Click the "Submit Support Data" button
  • Optionally enter a brief description of the problem
  • Wait for it to finish
  1. Copy the resulting support ID

Check the image below for visual steps:

waxen musk
#

GEP-F411-35A AIO

#

just plugged it back into betaflight and now the erls is flashing

#

e2b15e78-5d43-4b71-be89-d0b9d12d72e1

#

it is connecting now, not sure why.. thanks though

meager chasm
waxen musk
#

i did, but changed it after noticing the receiver wasnt in bootloader mode