obtuse kiln
Cheers!
So I have MAMBAF722 FC and want to send OSD over UART(using MSP+Displayport in ports configuration).
Funny thins is it works great, until I arm. Then only clear/draw messages coming (no writes for any OSD element). then I disarm and everything works just fine again and so on.
I struggle to find how Arming can block OSD stream(via MSP-displayport).
Would be very grateful for any pointers!
deft sparrow
Cheers!
So I have MAMBAF722 FC and want to send OSD over UART(using MSP+Display...
what loop and dshot rate are you running?
deft sparrow
I assume you are implying to reduce it?
sorry for the late response. Yes, bump it down to a 4K PID loop and DShot 300
obtuse kiln
hey there, I tried this and it didn't help unfortunately. at the moment I arm - only clear/draw messages incoming from uart.
Can you pls point to some spots in code where I might start digging into it, I assume it will be hard to find the reason withot looking into code,
thnx for help!
obtuse kiln
additional info: this drone has 4.3 firmware(it will be a mess to upgrade because it will take quite some effort to setup the drone once again, so I'd like to stick to whatever version it had rn).
I checked this workflow on another(speedy405) with 4.4.3 - and it works just fine. So it's either firmware version of FC itself. Maybe will try to upgrade sometime later.
thnx again!
vernal hound
Dod you tried change the uart
bronze mural
additional info: this drone has 4.3 firmware(it will be a mess to upgrade becaus...
Why would it take effort to setup? Save a diff, flash 4.5.1, restore your diff